Condre AutoTracer NAS Quick Start Manual
AutoTracer Standalone Quick Start Guide
The AutoTracer Standalone is an easy to use, reliable automated CD Duplication system that supports
multiple CD formats. The following is a Quick Start guide designed to allow the user immediate
operation of the unit:
Installation and Setup:
1. Unpack the AutoTracer Standalone and keep the external packaging for future storage and
transportation.
2. Place the AutoTracer Standalone on a flat, clean and dust free surface.
3. Connect the Power Cord from the back of the unit to an electrical outlet. The unit will
automatically power up and initialize. To power down the unit, simply unplug the power brick
from the base unit.
Operation:
1. Press the Reader drive button.
2. Load your Master CD into the Reader tray.
3. Press the Reader drive button to retract the CD into the drive.
4. Press the Writer drive button.
5. Load a blank CD into the Writer tray.
6. Press the Writer drive button to retract the CD into the drive.
7. Load the Input hopper ( on the right side of the system ) with up to 100 blank CD-R discs. For
optimum performance use Condre brand CD R media.
8. Press the “ Start” button to initiate the duplication process of the first disc ( the system takes
approximately 60 seconds to begin duplicating, while it catalogs the first Master disc ). Upon
completion of the first duplication, the robotics will automatically unload the Writer drive and
place the recorded disc in the output hopper ( on the left side of the system ). The system will
then pick a new blank disc from the input hopper and load the disc into the writer. The system
will then begin to duplicate the second disc from the original disc.
9. The system will continue the above process until the input hopper is empty. The user may
continually load the Input hopper during the duplication process to continue the job.
If an error occurs during the duplication process, the robotics will automatically pick the disc from the
Writer, and drop the disc in front of the unit. The Sequence and Pick buttons are used to calibrate the
system during initial setup or after being transported.
The AutoTracer Standalone is guaranteed to be free from defect in materials and workmanship for one
year. Condre assumes no responsibility for the illegal and distribution of audio, video and text /
graphics data. Call 952 294 4900 for Technical Support.