CONIC MRF-179 Instruction Manual - page 6
-5-
Before filling your Fridge/Freezer
/FREEZER.
The coolant fluid needs time to settle. If the appliance is switched off at any
time, wait 30 minutes before switching back on to allow the coolant fluid to
settle.
INSTALLATION
START
-6-
START
Super Freezing
1. Quick freezing allows moisture inside foodstuffs to form fine ice-
crystals which prevent the cell membrane from being damaged and
the cytoplasm being lost when unfreezing, thus the original freshness
and nutrition constituent of foodstuffs can be retained.
2. Fresh meal and fish to be stored for long time must be done by quick
freezing.To quick freeze turn the temperature knob to setting “7”
before adding food.
NOTE: the maximum allowable capacity is 3KG at a time.
3. After quick freezing, turn the knob back to the original position (
Normally time for quick freezing shall not exceeds 4 hours).
Is the Freezer/Fridge cold enough?
If you are at all concerned that your Fridge/Freezer is not being kept cold
enough, or you occasionally wish to check the temperature, you can purchase
a Fridge/Freezer thermometer. These are available from most supermarkets
and hardware shops.Place the thermometer in the Fridge compartment and
Switching on your Fridge/Freezer
1 Before connecting the Fridge/Freezer to the mains supply position. The
Thermostat control dial is located inside the Fridge compartment.
2 Turn the thermostat knob to the
position and turn on electricity. The
compressor and the light inside the refrigerator will begin to work.
3 Wait 24 hours before placing food into the Fridge/Freezer, the
temperature inside your Fridge/Freezer will then be cool enough to
chill and freeze foods sufficiently.
“3”
1. The temperature in the refrigerator and freezer compartment is
controlled by the temperature controller installed on the inside wall of
the refrigerator compartment. We strongly recommend you use a
freezer thermostat to check that the temperature is below -18
centigrade before loading any food. This can take 2 - 3 hours.
2. The marks on the knob are the temperature grades, NOT the exact
degrees of temperature. “0” is “OFF” and “7” represents the lowest
temperature.
Adjusting the temperature
NOTE: The Fridge/Freezer may not operate at the correct temperature
if it is in a particularly hot or cold room or if you open the Fridge/
Freezer door too often.
3. Please start with the knob set to position
“4”. Use a suitable
thermometer to check the temperature after two hours. The
refrigerator temperature should be set between +2ºC and +5º and the
freezer will vary between -18 and -25 degrees centigrade over a
typical cycle. To reduce the refrigerator temperature turns the knob
towards
and check after one hour.
“6”
Thermostat control dial
5
4
3
Before storing foods in
working properly and to allow the your Fridge/Freezer, turn the
Fridge/Freezer on and Fridge/Freezer to fall to the correct
temperature. See page 5 for more details.
wait for 24 hours, to make sure it is