Conklin FS CDN remote control User Manual - page 7
1. Initial Startup
1
1
1
.
.
I
I
n
n
i
i
t
t
i
i
a
a
l
l
S
S
t
t
a
a
r
r
t
t
u
u
p
p
When you connect power to your set-top box for the first time, you’ll
configure the set-top box and log in to fs|cdn.
I
MPORTANT
: Do not disconnect power to the set-top box until Startup
is complete. This will take up to 10 minutes. During this time the set-
top box will shut down and start up again, lights may flash or blink,
and messages will appear on your TV screen.
Startup is complete when the Welcome screen on your TV screen
prompts you for your password (see “Log in” on page 3).
Follow the instructions below to set up your system.
P
P
r
r
o
o
g
g
r
r
a
a
m
m
t
t
h
h
e
e
r
r
e
e
m
m
o
o
t
t
e
e
c
c
o
o
n
n
t
t
r
r
o
o
l
l
Before you can use the remote control, you’ll need to program it for
your TV brand.
1
Determine the brand of your TV (for example, Sony).
2
Find the brand in the list in “TV Brand Codes,” on page 50.
If you can’t find your TV brand in the list, try using the
code for a common brand (such as RCA or Samsung).
3
Simultaneously press and hold down the
TV
and
OK
buttons on the
remote until the
TV
button stays lit.
4
Use the number keys to enter the first 3-digit brand code listed for
the TV manufacturer.
If the
TV
button flashes rapidly for a second and
then stays lit, it means the remote doesn’t
recognize the brand code you entered. Enter the
next code listed for this brand, and continue down
the list until one works.
5
Verify that the
(
POWER
) and
VOL
buttons work.
6
Continue with “Validate the set-top box” on the next page.