Connect One II-EVB-361MW User manual - And Evaluation Program

II-EVB-361-

MW User’s Manual

5 

5.  Enter the AT+iRP11 command to obtain a report of all the Access Points 

available in your area. 

6.  Enter AT+iWLSI=ssid>. ssid is the ID of the Access Point you connect to. 

Note that ssid is a case-sensitive string. 

7.  If you want to enable WEP encryption, configure the following parameters: 

  AT+iWLWM=n> 

where n=0 means no security, n=1 means 64-bit 

key, and n=2 means 128-bit key 

  AT+iWLKI=n> where n is the WEP key index (n=1..4) 

  AT+iWLKn>=keyString> 

where n is an index between 1 and 4, and 

keyString is the WEP key string in the n

th

 position. 

8. 

If you want to enable WPA encryption, configure the following parameter: 

AT+iWLPP=passphrase>   

where passphrase is the pass-phrase to 

be used in generating the WPA1-PSK encryption key

At this stage a connection to the Access Point is established. To test the 

connection, use the iChip Config Utility to perform any activity that requires 

network connection such as retrieving a web page, sending an email, or 

opening a socket. 

Installing the II-EVB-361MW Utility 

and Evaluation Program 

II-EVB-361MW enables you to evaluate the Secure Socket iWiFi without changing 

anything in your current development environment. Using a simple terminal program 

on a PC, you can issue AT+i commands to the iChip and get responses. 

AT+i commands are used to configure parameter values into iChip’s flash memory 

and activate Internet tasks such as email send, sockets, FTP sessions, configuration, 

and more. 

A full description of the AT+i protocol can be found in the AT+i Programmer’s 

Manual on the Connect One website in the Documentation section at 

http://www.connectone.com

. 

To help you evaluate the iChip, Connect One supplies the iChip Config Utility. This 

is a Windows-based GUI program that contains intuitive dialog boxes to fully 

configure iChip. It doesn’t require any knowledge of AT+i commands. It also 

contains local firmware upgrade functionality. 

The iChip Config Utility also allows you to perform specific Internet communication 

tasks such as sending and receiving emails, activating iChip’s websites, entering 

SerialNET mode, and more. 

The latest iChip Config Utility version and user manual can be found on the 

Connect One website at 

http://www.connectone.com

 in the Support section. 

For more information on the iChip Config Utility and its usage, see the iChip Config 

Utility User’s Manual.