Connection Technology Systems HET-3012 SERIES User manual
Trademarks
CTS is a registered trademark of Connection Technology
Systems Inc. Contents subject to revision without prior
notice.
All other trademarks remain the property of their owners.
Copyright Statement
Copyright
Connection Technology Systems Inc.
This publication may not be reproduced as a whole or in
part, in any way whatsoever unless prior consent has been
obtained from Connection Technology Systems Inc.
FCC Warning
The HET-3012 SERIES have been tested and found to
comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These standards are designed
to provide reasonable protection against harmful
interference when these devices are operated in a
commercial environment. This device generates, uses, and
can radiate radio frequency energy that may cause harmful
interference to radio communications unless installed in
accordance with this User’s Guide. Operation of these
devices in a residential area is likely to cause harmful
interference which will make the user responsible for the
appropriate remedial action at his / her own expense.
CE Mark Warning
These are Class A products. In a domestic environment
these products may cause radio interference in which case
the user will need to consider adequate preventative
methods.
This is a
lead-free and
RoHS-compliant product.
1. Checklist
The package should contain the following items:
-
HET-3012 Converter
-
Power Adapter
-
User
’s Guide & Installation Guide
-
One screw
Please notify your sales representative immediately if any
items are missing or damaged.
2. Overview
HET-3012 SERIES are fully compliant with IEEE 802.3,
802.3u, 802.3ab & 802.3z standards and are designed to
meet the increasing needs for Fast Ethernet network
deployment. HET-3012 SERIES are able to extend a
copper-based network via fiber cable to a maximum
distance up to 80KM (the transmission distance varies
depending on fiber used).
On the top panel, HET-3012 provides a set of LED
indicators that allow users to monitor its real-time
operational status. In addition, the built-in cable tray is also
provided with HET-3012. Installing fiber cable in the cable
tray is fairly simple and different ways of installing fiber
cable enable users to choose the best installing method to
conform to converter placement needs or to overcome
placement restrictions.
Key Features:
-
Store and Forward Switching Mechanism
-
Fiber speed supports Auto-Sensing and
Auto-Negotiation (under dual rate mode)
-
MDI/MDIX Auto-Crossover supported
-
Support Fiber Auto Mode
-
Support Jumble Frame 9K bytes
-
Support 2K MAC address
3. Installation
Attach fiber cable from the HET-3012 to the fiber
network. The fiber connections must be matched
–
transmit socket to receive socket.
Attach a UTP cable from the 10/100/1000BASE-T
network to the RJ-45 port on the HET-3012.
Connect the power adapter to the HET-3012 and
check whether the Power LED indicator lights up. The
LAN and WAN LED indicator will light up when all the
cable connections are satisfactory.
Figure 1. HET-3012 front panel interface
Figure 2. HET-3012 top panel