Conrad FS20 RPT Operating Instructions Manual

Manual is about: Conrad Radio repeater operating instructions

Summary of FS20 RPT

  • Page 1

    Version 12/06 operating instructions radio repeater „fs20 rpt“ item no. 62 30 06.

  • Page 2: Introduction

    2 introduction dear customer, thank you for purchasing this product. This product meets the requirements of both current european and national guidelines. In order to preserve this condition and ensure the safe operation of the product we kindly ask you to carefully follow these operating instructio...

  • Page 3: Table of Contents

    3 table of contents page 1. Prescribed use ............................................................................................................... 3 2. Scope of delivery ........................................................................................................... 4 3. Explanati...

  • Page 4: 2. Scope of Delivery

    4 2. Scope of delivery • repeater • user manual 3. Explanation of icons the icon with a lightning flash in a triangle is used to alert you to potential personal injury hazards such as electric shock. This icon with an exclamation mark in a triangle points to particular dangers associated with the ha...

  • Page 5: 5. Safety Instructions

    5 5. Safety instructions the product’s guarantee becomes invalid if the product is damaged as a result of failure to observe these operating instructions. We do not assume any liability for any resulting damages! Nor do we assume liability for damage to property or personal injury caused by improper...

  • Page 6: 6. Functionality

    6 6. Functionality the repeater serves to increase the range of transmitters from the fs20 wireless control system. Radio commands sent by these transmitters can be repeated up to two times so that the range of the original transmission signal can be tripled (maximum) when two repeaters are used. Fi...

  • Page 7: 7. Operation

    7 7. Operation simply plug the repeater into a socket (230v~/50hz) with an earth connector. The repeater is then immediately ready for use. The repeater forwards a received command from the fs20 wireless control system with a repeater identifier. A slight time delay occurs as a result of the brief b...

  • Page 8: 9. Maintenance and Cleaning

    8 if the product is not operated for a longer period of time, disconnect it from the voltage supply, removing it from the socket. Avoid the following adverse ambient conditions at the installation location or during transport: - moisture or excessive air humidity - extreme cold or heat - dust or fla...

  • Page 9: 11. Tips and Notes

    9 11. Tips and notes ranges and interference • the fs20 wireless control system works in the 868mhz range, which is also used by other radio services. Therefore devices that operate on the same or neighbouring frequency may restrict both its operation and its range. • the specified range of up to 10...

  • Page 10

    10 12. Declaration of conformity (doc) we, conrad electronic, klaus-conrad-straße 1, d-92240 hirschau (germany), hereby declare that this product complies with the fundamental requirements and other relevant regulations of directive 1999/5/eg. You can find the declaration of conformity for this prod...

  • Page 11

    11.

  • Page 12: Imprint

    Conrad im internet http://www.Conrad.Com conrad im internet http://www.Conrad.Com imprint these operating instructions are published by conrad electronic se, klaus-conrad-str. 1, d-92240 hirschau/germany. No reproduction (including translation) is permitted in whole or part e.G. Photocopy, microfilm...