Summary of 10AL
Page 1
10al/10al-d manual (1.2 en).
Page 2
S y m b o l s o n t h e p r o d u c t p l e a s e r e f e r t o t h e i n f o r m a t i o n i n t h e m a n u a l . W a r n i n g ! D a n g e r o u s v o l t a g e ! General information 10al/10al-d manual version: 1.2 en, 05/2011, d2611.En .01 copyright © 2011 by d&b audiotechnik gmbh; all rights re...
Page 3
1. Safety precautions......................................................... 4 1.1. Information regarding the use of loudspeakers......... 4 2. 10al/10al-d loudspeaker......................................... 5 2.1. Product description...................................................... 5 2.2. C...
Page 4
1.1. Information regarding the use of loudspeakers potential risk of personal injury never stand in the immediate vicinity of loudspeakers driven at a high level. Professional loudspeaker systems are capable of causing a sound pressure level detrimental to human health. Seemingly non-critical sound ...
Page 5
2.1. Product description the 10s, 10a and 10al and their "d versions" are a family of high performance 2-way loudspeakers employing a single 10” driver in a bass-reflex enclosure and different hf sections for a wide range of installed sound applications. All models are lightweight passive designs us...
Page 6
2.2. Connections the cabinets are fitted with a pair of nl4 connectors and a two pole screw terminal block (st). All four pins of both nl4 connectors are wired in parallel. The cabinets use the pin assignments 1+/1–. Pins 2+/2– are designated to active subwoofers. Cabinets with the weather resistant...
Page 7
Nl4 connection with cover plate the two nl4 connector sockets of the cabinet's connector panel are located in a recess to allow the use of the cover plate [1] together with nl4 cable connectors, as shown in the graphic opposite. Note: neutrik nl4fc type connectors must be used for this option. The c...
Page 8
2.3.1. Controller settings for acoustic adjustment the functions cut, hfc and cpl can be selected. Cut circuit set to cut, the cabinet low frequency level is reduced. The cabinets are now configured for use with d&b active subwoofers. Hfc circuit selecting the hfc (high frequency compensation) circu...
Page 9
2.4. Dispersion characteristics the following graphs show dispersion angle over frequency of a single cabinet plotted using lines of equal sound pressure (isobars) at –6 db and –12 db. Fig. 8: isobar diagram horizontal 10al fig. 9: isobar diagram vertical fig. 10: isobar diagram horizontal 10al-d fi...
Page 10
10al/10al-d loudspeaker nominal impedance 12 ohms power handling capacity (rms/peak 10 ms) 200/1200 w nominal dispersion angle (horizontal) 10al 75° nominal dispersion angle (horizontal) 10al-d 105° splay angle setting 0°, 1°, 2°, 4°, 6°, 9°, 12°, 15° components 10“ driver with neodymium magnet 2 x ...
Page 11
3.1. Eu conformity of loudspeakers (ce symbol) this declaration applies to: d&b 10al loudspeaker, z1557 d&b 10al-d loudspeaker, z1558 manufactured by d&b audiotechnik gmbh. All production versions of these types are included, provided they correspond to the original technical version and have not be...
Page 12
D2611.En .01, 05/2011 © d&b audiotechnik gmbh www.Dbaudio.Com.