Summary of Ti10
Page 1
Ti10 manual 1.1 en.
Page 2
Symbols on the equipment please refer to the information in the operating manual. Warning! Dangerous voltage! Contents safety precautions..............................................................3 information regarding use of loudspeakers............................................3 ti10...........
Page 3
Safety precautions information regarding use of loudspeakers warning! Never stand in the immediate vicinity of loudspeakers driven at a high level. Professional loudspeaker systems are capable of causing a sound pressure level detrimental to human health. Seemingly non-critical sound levels (from ap...
Page 4
Ti10 fig. 1: ti10 loudspeaker fig. 2: ti10 horn and lens in line source setup fig. 3: ti10 horn and lens in point source setup the ti10 is the installation version of the t10 loudspeaker. It is a very compact loudspeaker system which can be used both as a line array and as a high directivity point s...
Page 5
Ti10l rigging procedure 1 2 4 3 fig. 4: assembly of a ti10l line array ti10l line arrays are set up using the z5370 t flying frame. The rigging procedure follows the description given in the t-series rigging manual which is provided with the t flying frame. However, ti10l and t10 cabinets have diffe...
Page 6
Connections 1+ 1- 2+ 2- 1+ 1- 2+ 2- passive crossover fig. 5: connector wiring the ti10 cabinet is fitted with a pair of nl4 connectors. All pins of both connectors are wired in parallel. The ti10 uses the pin assignments 1+/ 1–. Pins 2+/2– are designated to active subwoofers. Using one connector as...
Page 7
Controller settings for acoustic adjustment the functions cut, hfa, hfc and cpl can be selected. Cut circuit set to cut, the ti10 low frequency level is reduced. The ti10 is now configured for use with the ti-sub or other d&b active subwoofers. Hfa circuit (t10 ps setup only) -5 0 5 10 -10 -15 -20 -...
Page 8
Dispersion characteristics the graphs below show dispersion angle over frequency of a single ti10 cabinet plotted using lines of equal sound pressure (isobars) at – 6 db and –12 db. Fig. 9: isobar diagram ti10 line source, horizontal fig. 10: isobar diagram ti10 line source, vertical fig. 11: isobar...
Page 9
Technical specifications fig. 13: ti10 frequency response line source, single cabinet, standard and cut settings fig. 14: ti10 frequency response point source, standard and cut settings ti10 system data frequency response (–5 db standard)............................................68 hz ... 18 khz f...
Page 10
Manufacturer's declarations eu conformity of loudspeakers (ce symbol) this declaration applies to ti10l loudspeaker, z0551 ti10p loudspeaker, z0552 manufactured by d&b audiotechnik gmbh. All production versions of these types are included, provided they correspond to the original technical version a...