Operation manual d-cut flooring cutter md-330 www.Dcutproducts.Com.
2 safety rules for the flooring cutter 1. Read and understand this instruction manual before operating the d-cut multi-flooring cutters. 2. If you are not thoroughly familiar with the operation of d-cut multi-flooring cutter, obtain advice from a qualified instructor or call 630-916-9100 usa 3. Stay...
3 cutting and c installation install the table to the cutter base with provided screws and bolts as shown. Then insert the handle into the handle base as show and tighten provided screw. Warning: do not put your fingers against the sharp edge of the blade at any time. 45° cutting adjust the angle at...
4 changing the nylon bar use theprovided allan wrench to remove the five screws, then hold the nylon bar and carefully move it out of nylon bar holder. Warning: do not put your fingers against the sharp edge of the blade at any time. Transport insert the pin as shown to the hole in the aluminum ecce...
5 parts list.
6 parts q’ty parts q’ty 1 screw m5 × 10 4 24 handle b 1 2 washer Φ5 4 25 nut m4 2 3 rubber feet 4 26 right abs handle 1 4 rod 2 27 bolt m4 × 30 2 5 hex bolt m8 × 55 4 28 left abs handle 1 6 hex bolt m8 × 50 4 29 guide bar 1 7 main base 1 30 screw m5 × 8 9 8 screw m4 × 14 5 31 nut m10 8 9 nylon bar 1...
