1. DL manuals
  2. D-CUT
  3. Cutter
  4. MH-330
  5. Operation Manual

D-CUT MH-330 Operation Manual - Set Up

Manual is about: Multi-Flooring Cutter

Summary of MH-330

  • Page 1

    Operation manual d-cut multi-flooring cutter mh-330 www.Dcutproducts.Com.

  • Page 2

    2 safety rules for the multi-flooring cutter 1. Read and understand this instruction manual before operating the d-cut multi-flooring cutters. 2. If you are not thoroughly familiar with the operation of d-cut multi-flooring cutter, obtain advice from a qualified instructor or call 800-982-3434 usa 3...

  • Page 3: Set Up

    3 set up cutting and c installation of the cutter (2) pull up the lock pin on the aluminum handle as shown and insert the handle into the handle base as shown. Warning: do not put your fingers against the sharp edge of the blade at any time. Installation of the cutter (1) install the table to the cu...

  • Page 4: Cutting

    4 cutting straight cutting insert material between the cutting blade and the base, flush with the angle attachment as shown and hold the material with foot then push handle down to complete a cut. Warning: maintain control of the handle. Do not allow handle to slam back after making a cut. 45° cutti...

  • Page 5: Maintenance

    5 carry hook the chain to the ring on the handle and carry the cutter as shown. Changing the blade use theprovided allan wrench to remove the five screws, then hold the blade by each end and carefully remove the blade out of the blade holder. Note: the flat side of the blade faces the table. Warning...

  • Page 6: Part List

    6 part list.

  • Page 7: Part List

    7 parts q’ty parts q’ty 1 side frame a 1 29 hex head screw m5 × 8 9 2 customized bolt m8 2 30 hex head screw m8 × 8 4 3 spring washer Φ8 2 31 hook-2 1 4 hex head bolt m8 × 66 4 32 carrying handle 1 5 nylon board 2 33 end table frame 1 6 nylon bar holder 1 34 thin nut m5 3 7 hex head screw m12 × 30 1...

  • Page 8

    8 mh-230/ mh-330 cutting capacity chart wood flooring janka rate mh-230 mh-330 limit on engineered wood flooring limit on engineered wood flooring eastern white pine 380 yes yes basswood 410 yes yes white pine 420 yes yes hemlock 500 yes yes chestnut 540 yes yes larch 590 yes yes douglas fir 660 yes...

  • Page 9

    9 curupixa 1490 no no sapele / sapelli 1510 no no kambala 1540 no no peroba 1557 no no true pine / timborana 1570 no no zebrawood 1575 no no tualang 1624 no no wenge / red pine 1630 no no highland beech 1686 no no locust 1700 no no kempas 1710 no no merbau 1712 no no blackwood 1720 no no african pad...