1000base-tx to 1000base-sx/lx media converter user’s guide recyclable 19071001tsc6002 rev.1.01.
2 table of c ontents table of contents .......... 2 introduction ................. 3 a bout m edia c onverter ......................... 3 product features ...... 4 installation .................. 5 s electing a s ite for the e quipment ..... 5 c onnecting to p ower ............................. 5 i ...
3 i ntroduction thank you for choosing the 1000base gigabit ethernet media converter, the converter introduced here provides one channel media conversion between 1000base-tx and 1000base-fx. About media converter media converter is a network technology specified by ieee 802.3ab and ieee 802.3z 1000b...
4 p roduct f eatures y hot-swappable when used with a chassis y one-channel media conversion between 1000base-tx and 1000base-fx y fiber media allows: multi-mode fiber and single-mode fiber using sc connector y link pass through function y auto negotiation of duplex mode on tx port y auto mdi/mdi-x ...
5 i nstallation this chapter gives step-by-step installation instructions for the converter. Selecting a site for the equipment as with any electric device, you should place the equipment where it will not be subjected to extreme temperatures, humidity, or electromagnetic interference. Specifically,...
6 y first, install the converter onto a carrier supplied with the chassis: step 1- unscrew and pull out the media converter board. Step 2- plug in the media board to any of the vacant slot. Step 3- fit the converter onto the carrier and use the screw to secure it. Monitoring the converter through ma...
7 note: to control the function in a working station, need to collocate together with optional chassis system and management module. Led indicator the led indicators give you instant feedback on status of the converter: leds state indication lights on power on power (pwr) lights off power off lights...
8 the table below shows how llcf function is working: fib e r c o p p e r tx rx fib e r c o p p e r tx rx rx tx rx tx gig a b it switc h gig a b it switc h link 1 link 2 link 3 link 4 c a b le 1 ca b le 2 ca b le 3 c a b le 4 ca b le 5 me d ia c o nve rte r a me d ia c o nve rte r b link status disc...
9 link status disconnect link 1 link 2 link 3 link 4 cable 1 off off off off cable 2 off on on off cable 3 off off off off cable 4 off off off off note: if connecting two converters with llr function in both end, it is recommended that the monitor end converter had to turn off the llr function, and ...
10 same time. S pecifications standards: ieee802.3ab 1000base-tx ieee802.3z 1000base-sx/lx data transfer rate: 1488000pps for 1000mbps duplex mode: full duplex mode led indicators: pwr, lnk/act cable 1000base-t -- 4 pair cat. 5, eia/tia-568 100-ohm screened twisted-pair (stp), up to 100m 1000base-sx...
