D-Link 2624ix - Hub - Stackable User Manual - page 82
Manual is about: DFE-2600 Series Ethernet/Fast Ethernet Dual-Speed Managed/Unmanaged Stackable Hubs
of
147
Dual-Speed Stackable Hubs User’s Guide
Master Hub Setup and Management
70
(including TCP/IP parameters, SNMP parameters, the enabled/disabled set-
tings of ports, etc.) will be erased and restored to their factory default
settings.
1.
Choose Factory Reset NVRAM to Default Value from the main
menu. A confirmation message similar to that for the System Reset
will appear.
2.
Move the cursor to Yes to confirm the reset and press
After a few seconds delay, the hub should restart, and all of its
parameters will revert to their default values.
Note:
Doing a factory reset to the Primary Master al-
so resets the Backup Master variables except
for the the Backup Master IP address.