D-Link 300T - DSL - 8 Mbps Modem User Manual - page 30
DSL-300T ADSL Modem User’s Guide
To setup a PPPoA connection for the first time:
1. Type in a Name in the space provided if you wish or leave the default name.
2. Make
sure
PPPoA appears listed as the Type: of connection protocol used.
3. Do not change the VPI or VCI values unless you are required to do so. If these settings are incorrect, the
ADSL connection will not function. Many users will be able to use the default settings. If you are told to
change these, type in the values given to you by your service provider.
4. Leave
the
default
QoS values if you are unsure or the ISP did not provide this information.
5. Do not change the PCR or SCR values unless you are required to do so. If you are told to change these, type
in the values given to you by your service provider.
6. Supply
a
Username and Password used to verify the identity of your account. These are usually provided
by your ISP.
7. The
Encapsulation values LLC (SNAP) and VC (MUX) are two different methods of encapsulating the
PPP packet. Contact your ISP to make sure which encapsulation is being supported.
8. For most users, the remaining settings will not need to be changed. See your ISP for further information.
9. Click
the
Applybutton when you have entered all the information. The browser window may briefly go
blank. After a few seconds the new connection you just configured will become the active connection for the
Modem.
10. To make your temporarily saved connection permanent, click the Save All button in the System
Commands window on the Tools tab.
20