1. DL manuals
  2. D-Link
  3. Switch
  4. 55443
  5. Assembly Instructions Manual

D-Link 55443 Assembly Instructions Manual

Summary of 55443

  • Page 1

    0110562r4 page 1 of 8 assembly instructions before you begin, please make sure all parts and proper quanti- ties are included. Any parts damaged during shipment must be reported within 15 days of receipt. To report information regarding damages or if you have any questions, please call 1-800-235-126...

  • Page 2

    0110562r4 page 2 of 8 1. Assemble shelf a. Align and attach the shelf to the cord wrap bracket with (4) 8-32 x 3/8” phm screws as shown in figure 1. B. Using the narrow slots as guides, apply (6) 3” x 2” adhesive velcro ® pads (hook side) to the top of the shelf as shown. Cord wrap bracket 8-32 x 3/...

  • Page 3

    0110562r4 page 3 of 8 figure 3a 3. Usb hub wiring (#55444 only) a. Connect the usb cables to the hubs. See usb wiring diagram for reference. Figure 3a. Cord management slots excess cord bundled behind hub with zip tie figure 3b cord wrap typical wiring recommendation “feeder“ usb hub #7 mounted at 9...

  • Page 4

    0110562r4 page 4 of 8 figure 3c cord wrap bracket route cords through holes shelf top view rear view of shelf cord opening for usb or power plug figure 3e shelf bottom view feeder hub figure 3f cord opening for usb or power plug bundled usb cords figure 3d.

  • Page 5

    0110562r4 page 5 of 8 4. Attach shelf to cart a. Open the instructor-side doors on the cart (outlet-side) install (4) 8-32 x 1/2” ph thread cutting screws in the divider panel but do not tighten completely. Figure 4. B. Set the shelf assembly onto the 4 screws as shown. Tipping the shelf slightly wi...

  • Page 6

    0110562r4 page 6 of 8 5. Route cords a. On the instructor-side of the cart (outlet-side) route the usb cord from the feeder hub under the shelf up the inside wall of the cart to the worksurface. Figure 5a. The cord can be secured using the plastic cord clip inside the cart. B. Route the power cords ...

  • Page 7

    0110562r4 page 7 of 8 6. Usb hub start-up note: the hubs can be reset if a power failure occurs or if any of the hubs do not power up with the led light on. This reset procedure is for the synchronizing usb hubs included only. For all other usb hubs, refer to your specific hub instructions for furth...

  • Page 8

    0110562r4 page 8 of 8 warranty 925 first avenue, po box 400, chippewa falls, wi 54729 ph: 800-235-1262, 715-723-6750 fax: 800-335-0473, 715-738-2309 e-mail: spectrum@spectrumfurniture.Com web: www.Spectrumfurniture.Com specifications note: the ipad ® has a single cord for charging and syncing. This ...