D-Link AirPremier DWL-7200AP Quick Installation Manual - Connecting The Dwl-7200Ap to
4
There are two methods of powering the DWL-7200AP. The power adapter can plug directly
into the unit or plug into the PoE (Power over Ethernet) base unit. To connect power
directly to the DWL-7200AP, please follow the steps on this page. To use the PoE base
unit, please follow the steps on the next page.
Connecting Power Directly to the DWL-7200AP
A.
Connect the power adapter to the receptor on the back panel of the DWL-7200AP.
Connect the power cord to the power adapter. Plug the other end of the power
cord into a wall outlet or power strip. The Power LED will turn ON to indicate
proper operation.
B.
Insert an Ethernet cable into the
LAN port on the back panel of the
DWL-7200AP
and an available Ethernet port on the network adapter in the computer you will
use to configure the DWL-7200AP. The Link LED for the LAN Port will illuminate
to indicate a proper connection.
C.
Computers with 802.11a/b/g wireless adapters can connect to the DWL-7200AP.
The DWL-AG660 AirPremier
TM
AG Wireless Cardbus Adapter and the DWL-AG530
AirPremier
TM
AG Wireless PCI Adapter will connect with the DWL-7200AP, out of
the box, using the default settings.