Summary of DES-1008E
Page 2: Manual Revisions
English 2 d-link reserves the right to revise this publication and to make changes in the content hereof without obligation to notify any person or organization of such revisions or changes. Manual revisions trademarks d-link and the d-link logo are trademarks or registered trademarks of d-link corp...
Page 3: Table of Contents
English 3 table of contents preface ..................................................................................................... 2 manual revisions ........................................................................................2 trademarks .............................................
Page 4: Safety Instructions
English 4 to reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment, observe the following precautions. Observe and follow service markings. Do not service any product except as explained in your system documentation. Opening or removing covers that are marked with the...
Page 5
English 5 • tohelpavoiddamagingyoursystem,besurethevoltageselectionswitch(ifprovided)onthepowersupplyissettomatchthe power available at your location: – 115volts(v)/60hertz(hz)inmostofnorthandsouthamericaandsomefareasterncountriessuchassouthkoreaandtaiwan. – 100 v/50 hz in eastern japan and 100 v/60...
Page 6
English 6 static electricity can harm delicate components inside your system. To prevent static damage, discharge static electricity from your body before you touch any of the electronic components, such as the microprocessor. You can do so by periodically touching an unpainted metal surface on the ...
Page 7: Product Overview
English 7 product overview setup the setup of the des-1008e can be performed using the following steps: • thepoweroutletshouldbewithin1.82meters(6feet)oftheswitch. • visuallyinspectthedcpowerjackandmakesurethatitisfullysecuredtothepoweradapter. • donotcovertheventilationholesonthesidesoftheswitch,an...
Page 8
English 8 switching technology switches provide full-line speed and dedicated bandwidth for all connections. This is in contrast to hubs, which use the traditional shared networking topology, where the connected nodes contend for the same network bandwidth. When two switching nodes are communicating...
Page 9: Features
English 9 features • thedes-1008eisahighperformanceswitchdesignedspecificallyforenvironmentswheretrafficonthenetworkandthenumberofusers increase continuously. • thedes-1008e,withitssmall,compactsize,wasspecificallydesignedforsmalltomid-sizedworkgroups.Thedes-1008ecanbeinstalled wherespaceislimited;m...
Page 10: Hardware Overview
English 10 power indicator thisgreenindicatorlightisonwhenthedes-1008eisreceivingpower;otherwise,itisoff. Link/act this led indicator light is green when the port is connected to an ethernet device and will blink as ethernet data is transmitted or received. Hardware overview top panel (leds).
Page 11
English 11 auto mdi/mdi-x ports: allportssupportautomaticmdi/mdi-xcrossoverdetection.Theautomdi/mdi-xfunctionmakesitsimpletoconnecttotheswitch—justplug either a crossover or straight-through cat5 cable into any port. Power jack: power is supplied through an external power adapter. Check the technica...
Page 12: Installation
English 12 installation this section will explain how to connect ethernet devices to your new d-link switch and how to mount the switch. Before you connect to the network thesitewhereyouinstalltheswitchmaygreatlyaffectitsperformance.Pleasefollowtheseguidelinesforsettinguptheswitch. • installtheswitc...
Page 13
English 13 mounting the switch on the wall the des-1008e can also be mounted on a wall. Two mounting slots are provided on the bottom of the switch for this purpose. Please make sure that the front panel is exposed in order to view the leds. Please refer to the illustration below: mounting on a ceme...
Page 14: Connecting The Switch
English 14 connecting the switch pc to des-1008e a computer can be connected to the des-1008e via a two-pair category 3, 4, 5 utp/stp straight-through or crossover cable. A computer equipped with a rj-45 10/100mbps port can be connected to any of the eight des-1008e ports. The led indicators for the...
Page 15: Troubleshooting
English 15 troubleshooting 1. Why can´t i share my internet connection to multiple computers when using my d-link des-1008e switch? Ifyouareconnectingdirectlytoacableordslmodem,youwillneedarouterto“share”yourinternetconnectionoracomputerusingics (internet connection sharing) or proxy. Switches and h...
Page 16: Networking Basics
English 16 networking basics check your ip address after you install your new d-link adapter or if you already have an ethernet adapter installed on your computer, by default, the tcp/ip settings should be set to obtain an ip address from a dhcp server (i.E. Router) automatically. To verify your ip ...
Page 17
English 17 statically assign an ip address if you are not using a dhcp capable gateway/router, or you need to assign a static ip address, please follow the steps below: step 1 windows® 7 - click on start > control panel > network and internet > network and sharing center > change adapter setting. Wi...
Page 18: Glossary
English 18 glossary 1000base-lx a short laser wavelength on multimode fiber optic cable for a maximum length of 550 meters. 1000base-sx alongwavelengthfora“longhaul”fiberopticcableforamaximumlengthof10kilometers. 100base-fx 100mbps ethernet implementation over fiber. 100base-tx 100mbps ethernet impl...
Page 19
English 19 bandwidth information capacity, measured in bits per second, that a channel can transmit. The bandwidth of ethernet is 10mbps, the bandwidth of fast ethernet is 100mbps. Baud rate the switching speed of a line. Also known as line speed. Bootp the bootp protocol allows you to automatically...
Page 20
English 20 fast ethernet 100mbps technology based on the ethernet/cd network access method. Flow control – (ieee 802.3x) a means of holding packets back at the transmit port of the connected end station. Prevents packet loss at a congested switch port. Forwarding the process of sending a packet towa...
Page 21
English 21 mdi-x medium dependent interface cross-over. An ethernet port connection where the internal transmit and receive lines are crossed. Mib management information base. Stores a device’s management characteristics and parameters. Mibs are used by the simple network management protocol (snmp) ...
Page 22
English 22 spanning tree protocol – (stp) a bridge-based system for providing fault tolerance on networks. Stp works by allowing you to implement parallel paths for network traffic, and to ensure that redundant paths are disabled when the main paths are operational and enabled if the main paths fail...
Page 23: Technical Specifications
English 23 technical specifications standards • ieee802.310base-tethernet • ieee802.3u100base-txfastethernet protocol • csma/cd data transfer rate ethernet: • 10mbps(half-duplex) • 20mbps(full-duplex) fast ethernet: • 100mbps(half-duplex) • 200mbps(full-duplex) topology • star network cables •10base...
Page 24
English 24 humidity • operating:10%~90%rh,non-condensing • storage:5%~90%rh,non-condensing dimensions (w x h x d): • 165.1 x 111.8 x 38.1 mm (6.5 x 4.4 x 1.4 inch) emi: • fcc class b, ce class b security: • cul + cb transmission method: • store-and-forward ram buffer: • 57kbytesperdevice filtering a...
Page 25
English 25 contacting technical support u.S. And canadian customers can contact d-link technical support through our web site or by phone. Before you contact technical support, please have the following ready: • modelnumberoftheproduct(e.G.Des-1008e) • hardwarerevision(locatedonthelabelonthebottomof...
Page 26: Registration
English 26 product registration is entirely voluntary and failure to complete or return this form will not diminish your warranty rights. Registration version 1.1 may 18, 2010