Review package contents make sure that the package contains the following items. If any items are missing, contact the reseller. § dfl-300 firewall § manual § quick install guide § ac power adapter connecting the dfl-300
Connecting the dfl-300 continued… to setup the dfl-300, begin by connecting the ac adapter to a power source. The power led on the front of the dfl-300 should now be on. Connect one end of the ethernet cable to the internal/lan port of the dfl-300 and the other end of the cable into a hub or switch ...
Setting up the computer continued… highlight the tcp/ip setting for the installed ethernet network adapter. Click properties at this screen, select the ip address tab. Select obtain an ip address automatically. Click ok if you are prompted to restart your computer, please do so. When the computer re...
Configuring the dfl-300 note: the dfl-300 requires internet explorer 4.0 or higher, or netscape communicator 4.0 or higher. Please open your web browser and enter this url: http://192.168.1.1 this will launch the dfl-300’s integrated web-based management system. This enter network password pop-up sc...
Configuring the dfl-300 continued… if your isp requires you to enter a username/password for a pppoe connection, choose pppoe (adsl user) fill in your pppoe username and password provided by your isp. Click ok at the bottom when done. -5-.
Configuring the dfl-300 continued… if your isp assigns you a dynamic ip address, choose dynamic ip address (cable modem user) fill in the hostname if provided by your isp. Click ok at the bottom when done. -6-.
Configuring the dfl-300 continued… if your isp assigns you a static ip address, choose static ip address fill in the static ip information provided by your isp. Click ok at the bottom when done. Now set up the outgoing policy. Click on policy on the left menu. Then click outgoing below it. -7-.
Configuring the dfl-300 continued… click on new entry and enter the following: source address: inside_any destination address: outside_any service: any action: permit click ok there should now be an outgoing policy created. This policy will allow all computers in the internal network to access the i...
Creating a vpn ipsec tunnel this example will demonstrate how to create a virtual private network (vpn) between two remote locations through the internet. The vpn policy will use ipsec to securely send/receive encrypted data over the internet. This example will consist of two dfl-300 office firewall...
We will begin by configuring the dfl-300 at site a . Start by going into the web configuration. Once in, go to the vpn menu. You should now be under vpn>autokey ike. Click new entry please fill in the appropriate information for site a. Name: site_a from source: internal subnet/mask: 192.168.10.0/25...
There should now be a vpn policy created for site a. Site a is now complete, we will now configure site b with the other dfl-300. Follow the same steps previously with site a to create a vpn policy. Please change the appropriate ip information. Name: site_b from source: internal subnet/mask: 192.168...
Technical support d-link provides free technical support for customers within the united states during the warranty period. U.S. Customers can contact d-link technical support through our web site, by e-mail or by phone. D-link technical support over telephone : (949) 790-5290 6 a.M. To 6 p.M. Monda...
