D-Link DG-104SH User Manual - Using The Boot Menu

DG-104SH VoIP Station Gateway

5

Using The Boot Menu

The DG-104SH VoIP gateway features a Boot Menu, which is described in this chapter.

To access the Boot Menu, you must first make sure the console is connected to the Diagnostics port (an RS-232 port

with a 9-socket D-shell connector and DCE-type wiring) and the appropriate cabling for the connection is being

used.  Please see the previous chapter, “Configuration,” for additional information. Next, power the device on by

simply plugging it in. You will see the  POST test and the boot up process. During this process, press to

reach the Boot Menu. If the boot up process has proceeded too far and you did not reach the Boot Menu shown

below, unplug the device, plug it back in (to restart the boot up process), and press until the Boot Menu

appears.

Boot Menu---Opening screen

Configure IP

This screen allows you to enter information necessary for the initial configuration of this device.

Use the   key to highlight the first menu item on the Boot Menu, Configure IP, and press . The  IP

Configuration

 screen will be displayed: