D-Link DGE-560SX Quick Installation Manual - Hardware Installation

2

Hardware Installation 

Before you start, make sure to turn off your computer and unplug the 

power cord. 

1. Shut 

down 

the 

computer 

and unplug the power cord. 

2.  Remove the chassis cover. 

3.  Insert the card into an empty PCI-Express slot. 

4.  Replace the computer chassis cover. 

5.  Reconnect the power cord and turn the computer on. If the BIOS section of 

your computer is plug and play compliant, then at the power up the BIOS will 

automatically recognize and configure any newly installed DGE–560SX 

Adapter. 

Installing the DGE-560SX Driver 

1. Turn 

on 

the 

computer. 

2.  Insert the driver CD included with the DGE–560SX into the CD ROM. 

3.  For Windows OS, the screen shown below will appear automatically. Click 

Install Driver and follow the instructions on the installation wizard. The 

following drivers are supported: 

Caution:  To avoid damage caused by static electricity, make sure to properly 

ground yourself by first touching a metal part of your computer to discharge any 

static electricity before working with the DGE-560SX Ethernet Adapter.