1. DL manuals
  2. D-Link
  3. Media Converter
  4. DMC-805X
  5. User Manual

D-Link DMC-805X User Manual - Link Pass Through Function

Manual is about: 10G CX4 To 10G SFP+ MediaConverter

Summary of DMC-805X

  • Page 2: Fcc Class A Certification

    2 fcc class a certification this equipment has been tested and found to comply with the limits for a class a digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial en...

  • Page 3: Introduction

    3 introduction thank you for choosing the dmc-805x, a 10g cx4 to 10g sfp+ media converter. The dmc-805x` converts 10g cx4 signals to 10g fiber signals. Comes with an sfp+ slot for user-selectable fiber transceivers and extends the network connection to various lengths depending on sfp+ transceiver c...

  • Page 4: Product Features

    4 product features compliance with ieee802.3ak cx4 xaui and ieee802.3ae/aq 10gbase sfp+ one-channel media conversion between 10gbase-cx4 and 10gbase-sr/er/lr/lrm/zr sfp+ module extends network connection to various lengths depending on sfp+ transceiver capability used as stand-alone converter or ins...

  • Page 5: Connecting to Power

    5 1. The ambient temperature should be between 32 and 104 degrees fahrenheit (0 to 40 degrees celsius). 2. The relative humidity should be less than 90 percent, non-condensing. 3. Surrounding electrical devices should not exceed the electromagnetic field (rfc) standards for iec 801-3, level 2 (3v/m)...

  • Page 6

    6 follow up the following steps to install the converter onto a carrier supplied with d-link special designed chassis (dmc-1000): step 1- unscrew and pull out the media converter board. (refer to figure 1) step 2- plug in the media board to any of the vacant slot. (refer to figure 2) step 3- fit the...

  • Page 7: Module (Dmc-1002)

    7 monitoring the converter through management module (dmc-1002) there is a management module named as dmc-1002 that can control this media converter through d-link special designed chassis system (dmc-1000), this media converter can be controlled through web browser, snmp and terminal emulation prog...

  • Page 8: Led Indicator

    8 led indicator the led indicators give you instant feedback on status of the converter: leds state indication lights on power on pwr (power) lights off power off lights on linking lights blinking data transmitting and receiving cx4 lights off not linking lights on linking lights blinking data trans...

  • Page 9: Link Pass Through Function

    9 link pass through function (llcf) link loss carry forward when a device connected to the converter and the cx4 xaui lost the link connection, the converter’s fiber will disconnect the link of transmit, so that the other ends will know that there is a linkage error on this end. And when the fiber l...

  • Page 10: Link Pass Through Function

    10 link pass through function (llr) link loss return when a device connected to the converter and the fiber line lot the link, the converter’s fiber will disconnect the link of transmit. There is a switch to enable or disable the function of the media converter. The table below shows how llr functio...

  • Page 11: Switch

    11 switch there is one pin dip switch on the module which defines as switch 1: switch 1: llr when the switch was turned to “on”, it means that the llr was enabled and “off” for disabled. Note: when using two converters, don’t enable the both devices’ llr function at the same time. Figure 5.

  • Page 12: Specifications

    12 specifications standards: ieee802.3ak 10gbase-cx4 ieee802.3ae/aq 10gbase-sr/er/lr/lrm/zr data transfer rate: 20gbps duplex mode: full duplex mode led indicators: pwr, cx4, sfp+ supported sfp+ transceivers dem-431xt: 10gbase-sr sfp+ transceiver (w/o ddm), 80m: om1 & om2 mmf,300m: om3 mmf dem-431xt...

  • Page 13

    13 cx4 cable 10gbase-cx4 xaui 4-lane pcs (clause 48) and copper cabling similar to that used by infiniband technology, up to 15m dip switch bit 1: off: llr disable(default) on: llr enable dimensions l120 × w88 × h25 mm power external power adapter 12v/0.5a temperture: storage: -10 °c ~ 70°c (14 ~ 15...

  • Page 14: Notes

    14 notes.

  • Page 15: Notes

    15 notes.

  • Page 16

    Ver. 1.00(ww) 2012/03/29 29071600dm805x0