D-Link DSL-500G User Manual - About This User’S Guide
DSL-500G ADSL Ethernet Router User’s Guide
About This User’s Guide
This user’s guide provides instructions on how to install the DSL-500G ADSL Router and use it to connect a
computer or Ethernet LAN to the Internet.
If you are using a computer with a functioning Ethernet port, you can use the Quick Installation Guide to quickly
establish your ADSL connection and access the Internet.
Guide Overview
Introduction – Describes the Router and its key features. Provides an introduction to ADSL. Lists
standards to which the Router complies. Contains a packing list.
Hardware Installation – Discusses how to connect the Router to an Ethernet LAN.
First Time Set Up – Provides information on how to configure the Router and establish the ADSL
connection using the web-based manager.
Web-based Configuration – Describes how to use the web-based manager to change Router settings and
configure additional virtual connections (PVCs).
Appendix A - Technical Specifications – Lists the technical specifications of the Router, including
standards compliance.
Appendix B - Low Pass Filters – Contains illustrated examples of how to use low pass filters.
Before You Start
Please read and make sure you understand all the prerequisites for proper installation of your new Router. Have
all the necessary information and equipment on hand before beginning the installation.
Installation Overview
The procedure to install the Router can be described in general terms in the following steps:
1. Gather information and equipment needed to install the device. Before you begin the actual installation
make sure you have all the necessary information and equipment.
2. Install the hardware, that is, connect the cables (Ethernet and telephone) to the device and connect the
power adapter.
3. Check the IP settings on your computer and change them if necessary so the computer can access the
web-based software built into the Router.
4. Use the web-based management software to configure the device to suit the requirements of your ADSL
account.
Requirements
To install and use the Router you need a computer equipped with an Ethernet port (such as an Ethernet NIC) and
a web browser. You may also need to use information given to you by your ISP or ADSL service provider. This
information is stored in the Router’s memory and used to establish the ADSL connection and confirm your
identity. Read the next page for more details about these requirements.
Low Pass Filters
Since ADSL and telephone services share the same copper wiring to carry their respective signals, a filtering
mechanism may be necessary to avoid mutual interference. A low pass filter device can be installed for each
telephone that shares the line with the ADSL line. These filters are easy to install passive devices that connect to
the ADSL device and/or telephone using standard telephone cable. Ask your service provider for more
information about the use of low pass filters with your installation. Appendix B provides illustrated examples of
how to install two common styles of low pass filters.
vii