D-Link DWL-6700AP Quick Installation Manual - Lis
D-Link DWL-6700AP Quick Install Guide 3
E
NG
LIS
H
Power on the access point
To power on the DWL-6700AP, you can only use
the proprietary PoE adapter included with the
DWL-6700AP.
1. Connect the supplied PoE adapter and power
cord to the AC power source.
2. Plug one end of an Ethernet cable into the
LAN1 (or LAN2) port of the DWL-6700AP
and the other end into a PoE out from a PoE
adapter.
• Manage the access point from the computer:
Connect the access point and your computer
directly via a straight-through Ethernet cable.
Installation
Computer
DWL-6700AP
Computer
DWL-6700AP
Computer
DWL-6700AP
Switch or Router
Reset Button
Reset Button
LAN (Data in)
LAN1 Port (PoE in)*
LAN2 Port (PoE in)*
PoE out
(Connect to DWL-
6700AP's LAN1 or LAN2
Configure the access point
To set up and manage the DWL-6700AP, use one
of the following methods:
• LAN1 or LAN2 on DWL-6700AP to Ethernet
Port labeled POE on PoE Adapter
• Connect the Power Cord to the PoE Adapter
and a power outlet
• Connect Computer to Ethernet Port labeled
LAN on PoE Adapter
Figure 2. DWL-6700AP Rear Panel
Interfaces
• Manage the access point from the computer
via the Switch or Router: Connect the access
point and your computer to the same switch
or router.
* DWL-6700AP can be powered by the included PoE
adapter from either LAN1 or LAN2
Figure 3. PoE Adapter Panel
Figure 4. Deployment Example
LAN
Power
Active
POE
RST
LAN1 or LAN2
on DWL-6700AP
to Ethernet Port
labeled PoE on
PoE Adapter
Connect the
Power Cord to
the PoE Adapter
and a power
outlet
Connect Computer to
Ethernet Port labeled
LAN on PoE Adapter
LAN
PoE
POWER IN
Computer
DWL-6700AP