D-Link DXS-1210 Series User Manual - 5 Command Line Interface
5 Command Line Interface
D-Link DXS-1210 Series User Manual
102
save {startup-config | config-1 |
config-2}
Save configuration.
boot image [image-1 | image-2]
Select the boot up image.
debug info
Displays Debug Table.
debug show tech-support
Displays technical support information.
Each command is listed in detail, as follows:
?
Purpose
To display a list of commands.
Syntax
?
Description
The ? command displays a list of commands of the switch.
Parameters
None.
Restrictions
None.
Example usage:
To display a list of commands of the switch:
DXS-1210-12TC> ?
USEREXEC commands :
config ipif
config ipif
dhcpv6_client
debug info
logout
ping [
<1-100>>] [repeat
reboot
reset config
save
show ipif [INTERFACE-ID]
show switch
DXS-1210-12TC>
config ipif
Purpose
To configure the System IP interface.
Syntax
config ipif
config ipif
<1-128> | dhcpv6_client
Description
The config ipif system command configures the System IP
interface on the Switch.
Parameters
short <1-4094>
− Specifies the name of ipif setting.
ipaddress
− The IP address and subnet
mask to be created. Users need to specify the address and mask