D-Link xStack DGS-3200 Series Hardware Installation Manual - Section 1
xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
11
Section 1
Introduction
Switch Description
Features
Ports
Front-Panel Components
LED Indicators
Rear Panel Description
Side Panel Description
This manual describes the installation, maintenance, and configurations concerning the Switch.
Switch Description
D-Link's next-generation DGS-3200 Series is a high performancee member of the D-Link xStack
®
family. Ranging from
10/100Mbps edge switches to core gigabit switches, the xStack
®
switch family has been future-proof designed to provide fault
tolerance, flexibility, port density, robust security and maximum throughput with a user-friendly management interface for the
networking professional
The Switch has a combination of 1000BASE-T ports and SFP ports that may be used in uplinking various network devices to the
Switch, including PCs, hubs and other switches to provide a gigabit Ethernet uplink in full-duplex mode. The SFP (Small Form
Factor Portable) combo ports are used with fiber-optical transceiver cabling in order to uplink various other networking devices
for a gigabit link that may span great distances. These SFP ports support full-duplex transmissions and can be used with
DEM-310GT (1000BASE-LX), DEM-311GT (1000BASE-SX), DEM-312GT2 (100BASE-SX), DEM-314GT (1000BASE-LH),
and DEM-315GT (1000BASE-ZX) transceivers. Additionally, the SFP ports can be used with DEM-210 (Single Mode
100BASE-FX) and DEM-211 (Multi Mode 100BASE-FX) transceivers. Users may also use one of the WDM Single Mode
Transceivers, such as the DEM-330T/R or the DEM-331T/R.