D-Link xStack DGS-3426P Hardware Installation Manual - Features
xStack
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
10
Features
The list of features below highlights the significant features of the xStack
®
DGS-3400 Series.
•IEEE 802.3z compliant
•IEEE 802.3x Flow Control in full-duplex compliant
•IEEE 802.3u compliant
•IEEE 802.3ab compliant
•IEEE 802.3ae compliant (for optional XFP module)
•IEEE 802.1p Priority Queues
•IEEE 802.3ad Link Aggregation Control Protocol support.
•IEEE 802.1X Port-based and MAC-based Access Control
•IEEE 802.1Q VLAN
•IEEE 802.1D Spanning Tree, IEEE 802.1W Rapid Spanning Tree and IEEE 802.1s Multiple Spanning Tree support
•IEEE 802.3af Power-over-Ethernet support for the DGS-3426P
•Stacking support in either Duplex-Ring or Duplex-Chain topology
•Access Control List (ACL) support
•IP Multinetting support
•Protocol VLAN support
•Single IP Management support
•Access Authentication Control utilizing TACACS, XTACACS, TACACS+ and RADIUS protocols
•Dual Image Firmware
•Simple Network Time Protocol support
•MAC Notification support
•System and Port Utilization support
•System Log Support
•High performance switching engine performs forwarding and filtering at full wire speed up to 128Gbps.
•Full- and half-duplex for all gigabit ports. Full duplex allows the switch port to simultaneously transmit and receive data. It
only works with connections to full-duplex-capable end stations and switches. Connections to a hub must take place at half-
duplex.
•Support broadcast storm filtering
•Non-blocking store and forward switching scheme capability to support rate adaptation and protocol conversion
•Supports by-port Egress/Ingress rate control
•Efficient self-learning and address recognition mechanism enables forwarding rate at wire speed
•Support port-based enable and disable
•Address table: Supports up to 8K MAC addresses per device
•Supports a packet buffer of up to 3 Mbits
•Port Trunking with flexible load distribution and fail-over function
•IGMP Snooping support
•MLD Snooping support (MLD v1 and v2)
•SNMP support