""mic mic-amp -amp"" user manual manual page 1.
Geachte klant, wij danken u hartelijk voor uw keuze en het vertrouwen dat u in ons produkt stelt. U deed een goede keus, dit produkt is ontworpen door en voor professionele gebruikers. Er is gebruik gemaakt van onze enorme "know how" in mengtafel en signaal processor technieken en dit gekombineerd m...
Precautions: the product you have just unpacked is manufactured with safety in mind and is double checked in the test department for reliability in its high-voltage section. The mic-amp operates on 115 volt or 230 vac, 50/60 hz. In some products there is a voltage-selector built in on the rear panel...
Mic-amp this two channel pre-amp is designed to be the answer for extremely high quality microphone amplification especially on equipment which only are provide with line inputs. It transforms the balanced microphone-level signal to an unbalanced -10 dbv line-level signal to correspond to the line i...
Microphone input the mic-amp has two separate microphone inputs, each on an xlr connector. Wiring diagram for in/output connectors inputs xlr female pin 2 = in phase pin 3 = out of phase pin 1 = ground outputs xlr male pin 2 = in phase pin 3 = out of phase pin 1 = ground the mic-amp has two separate...
Dimensions 201 x 44 x 175 mm (w/h/d) (excl. Controls) 201 x 44 x 198 mm (w/h/d) (incl. Controls) 9,5" x 1he (w/h) weight approx. 1,7 kg cleaning clean the cabinet, panel and controls with a dry soft cloth. Do not use a moistened cloth or any type of solvent, such as alcohol or any other spirit, whic...
Declaration of conformity manufacturers name: d&r electronica weesp b.V. Manufacturers address: rijnkade 15b, 1382 gs weesp, the netherlands declares that the product mic-amp conforms to the following product specifications: emc: en 55022: 1987 cispr 22 (1993) class b en 500082-1 (1992) supplementar...
Product safety this product is manufactured with the highest standards and is double checked in our quality control department for reliability in the "high voltage" section. Caution never remove any panels, or open this equipment. No user servicable parts inside. Equipment power supply must be groun...
Allthough removing the ground wire sometimes cures a system hum, it will create a very hazardeous situation for the performing musician. Always earth all your equipment by the grounding pin in your mains plug. Hum loops should be only cured by proper wiring and isolation input/output transformers. R...
