D.T. System ULTRA MIN-E 2090 Owner's Manual - How to Test Your Collar
9
•
If you store your collar in a drawer or on a shelf or other flat
surface, keep your key ring magnet separated and away from the
collar receiver to help prevent accidental activation. Occasion-
ally check your collar, when not in use or stored, to ensure that it
has not been activated.
•
As with any electronic device which uses replaceable/disposable
type batteries it is always recommended that you keep an extra
set of batteries on hand. This will prevent any training delays
when the batteries need to be replaced.
How to Test Your Collar
A) Place the contact terminals of the
test lamp firmly onto the
electrodes of the receiver.
B) Set the stimulation to level 5 or 6.
C) Use the serrated edge of the test
light and gently rub it across the
sensor.
D) A red light on the test light should
light up.
NOTE
When rubbing the serrated edge of the test light across
the sensor do not press down hard. Instead run the tester
all the way from one end to the other with a quick motion
using a very light amount of downward pressure. Do not
be discouraged if it takes a few tries to get the hang of it.