1. DL manuals
  2. D.T.Systems
  3. Pet Care Product
  4. SPT 2420
  5. Owner's Manual

D.T.Systems SPT 2420 Owner's Manual

Manual is about: SPT SERIES, Electronic Dog Trainer

Summary of SPT 2420

  • Page 1

    • spt 2420 • spt 2422 • spt 2430 • spt 2432 spt series electronic dog trainer owner’s manual.

  • Page 2

    2.

  • Page 3

    Congratulations and thank you for purchasing one of our dog training systems. The spt series represents the absolute latest techno- logical advancement in the electronic dog training world. They offer compact, lightweight collar receivers which include completely internal antenna systems. The conven...

  • Page 4: Table Of Contents

    4 table of contents • introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 • table of contents . . . . . . . . . . . . . . . . . . . . . . . .4 • features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 • package contents . . . . . . . . . . . . . . . . . . . . . ...

  • Page 5: • Transmitter

    • transmitter • collar receiver (two for spt 2422 and spt 2432: one orange collar, one black collar) • 4” antenna for the transmitter • built-in rechargeable batteries in the collar(s) and the transmitter • battery charger • splitter jack cable for simultaneous charging • test light • owner’s manual...

  • Page 6: Individual Model Features

    Individual model features spt 2420 and spt 2422 • the spt 2420 features momentary (nick) stimulation, continuous stimulation, jump stimulation (patent pend- ing), rise stimulation (patent pending) and positive vibration. • the spt 2422 has the same features as the spt 2420 and comes with two collar ...

  • Page 7: Collar For Proper Fit

    Adjusting & positioning your collar for proper fit proper collar tightness and position are very important to insure safety and correct functioning every time you use the collar. • all electronic collars need to be very snug to work properly. They must be just tight enough to allow the “prongs” or e...

  • Page 8: Parts & Functions

    Parts & functions 8 transmitter (spt 2430 shown, models may vary slightly).

  • Page 9: Parts & Functions Cont.

    Parts & functions cont. Lcd display indicators collar receiver (spt 2430 model shown) 9.

  • Page 10: Turning The Unit On:

    Turning your unit on & off turning the unit on: press and hold the power button on the collar receiver. The red led indicator will light solid for two seconds. Continue holding the button until the red led light goes off. The unit is now on. The led indicator will now flash approximately every 2 sec...

  • Page 11: Intensity Level

    Intensity level the first and most important step in training your dog with your spt training system is the determination of the cor- rect intensity level to provide the proper training stimula- tion without over stimulating your dog. To do this, place the collar on and place it on the dog’s neck. P...

  • Page 12: Intensity Level (Cont.)

    Intensity level (cont.) setting the jump level 1. Press and hold both the “jump” button and one of the intensity level buttons at the same time ("intensity up" button for increase, "intensity down" button for decrease). 2. Release only the intensity level button when approxi- mate desired intensity ...

  • Page 13: Remote Training Buttons

    Remote training buttons 13 your spt 2400 series collar has four control buttons on the front of the transmitter and up to three buttons on the left side of the transmitter (1 button on spt 2420 and 2422 models, 3 buttons on spt 2430 and 2432 models). Pressing the “nick” button applies a very quick s...

  • Page 14: Switching Between Collars

    Switching between collars (two dog models) 14 with spt two dog systems (2422 & 2432) you can control two dogs with one transmitter. The lcd display shows whether you are currently controlling the orange collar receiver (org) or the black collar receiver (blk). To switch the currently active col- lar...

  • Page 15: Batteries

    Batteries • all training collars are equipped with rechargeable nickel-metal hydride (nimh) batteries which are not memory sensitive and do not require depletion before recharging. • when the battery is running low in the transmitter, the back- light will blink 3 times every second to alert you of t...

  • Page 16: Testing

    16 testing there are two or three methods you can use to test your depending upon your model’s features. First, you should make sure that both the transmitter and receiver are fully charged. Then, turn on the power to the collar receiver. Next, follow one of these three steps: to test the electronic...

  • Page 17: Testing

    Testing to test the beeper: (spt 2430 and 2432 only) a) press the locate button (top button on left side of transmitter). The collar should beep anytime this button is pressed b) press the run/point mode button (middle button on left side of transmitter). The unit is now in the run and point mode. I...

  • Page 18: Maintenance

    • it is very important to periodically clean your for maximum performance. Regular cleaning will also lengthen the life of your unit. • clean the collar box with lukewarm water and a mild anti-bacterial soap. • take care to thoroughly clean the space between the electrodes and the belt. • the belt a...

  • Page 19: Important Safety Notes

    19 important safety notes • before beginning training your dog should be examined by a veterinarian to assure that there are no physical reasons for your dog’s excessive barking and to assure that your dog in good health. • your is a very valuable tool if used correctly. Therefore, it is extremely i...

  • Page 20: Warranty

    20 warranty d.T. Systems premium lifetime warranty is the best war- ranty offered in the industry. This warranty is free to par- ticipating u.S. Customers. (the warranty registration card must be returned within 30 days of original purchase). This changes our normal one year parts and labor warranty...

  • Page 21: Warranty (Cont.)

    21 warranty (cont.) how the limited lifetime warranty works: - to qualify for the warranty you must fill out the warranty registration card which came with your system and mail it (with your original sales receipt) to d.T. Systems within 30 days of purchase. - there is no charge for parts or labor f...

  • Page 22: Fcc Compliance

    22 fcc compliance your \ has been manu- factured under complete compliance with the federal communication commission (fcc). The complex internal structure of each product has been designed to operate with- in specific regulations of fcc specifications. Any unautho- rized modifications to your produc...

  • Page 23

    23.

  • Page 24

    2872 walnut hill lane dallas, texas 75229 tel: (214) 350-9446, (888) luv-u-dog fax: (214) 350-7847 website: http://www.Dtsystems.Com e-mail: customerservice@dtsystems.Com.