-1- da1280 cordless telephone plug dect and cat-iq manual page 3 start-up with dect gap basisstation 4 connect analog terminal 5 operation : telephone, telefax 6 operation : hints 7 switch into ex-works-setup 8 change ex-works-setup parameters: method 1 9 configuration codes 10 change ex-works-setup...
-2- congratulations da1280 represents an analogue telephony plug which setup communication link to a dect-base station. Da1280 can connect legacy analogue terminals as corded telephones, fax, answering machine, modem or pos terminal via dect to your ip access point. Da1280 is compatible to all comme...
-3- start-up with standard dect base 1. Switch-on da1275 near base station 2. Switch-on repeater mode of dect base station (see manual of dect base station) 3. Press „registration“ at dect base station 4. Wait till da1275 is in operational mode *1) read pages 8-10 in case pin of your dect base is no...
-4- connect analogue terminal use wall-plugs for da1280 with leds on top. Please take care that rj11 cable does not exceed 3 meters. Connect your analogue terminal with rj11 cable to da1280. In germany in most cases a standard tae adapter is necessary. You can immediately use your analogue terminal ...
-5- operation incoming call led3 is flashing and connected terminal will be signalising incoming call. Accept call with terminal and led3 stops flashing and shows led3 active. Outgoing call (overlay dialing) hook-off analogue terminal. Led3 shows active and dialing tone will be announced. Analogue t...
-6- operation hints in case internal calls are enabled, you can call internal dect handsets with following sequence: **{handset int number}# possible {handset int number} are 1,2,3,5,6,7,8,9 please notice that „internal call enabled“ and „transparent mode on“ cannot be activated simultaneously. If „...
-7- ex-works-setup description ex-works status fax/modem off internal call off end symbol # transparent mode off caller rights incoming/outgoing calls dtmf signaling off flash time 300ms auto dialling off restore ex-works-setup press side key for 5 seconds to activate the reset of da1280. Reset func...
-8- change ex-works-setup method 1: connect a corded analogue phone to da1280 and use its keypad for entering configuration codes. Follow the instructions below activate configuration mode 1. Disconnect da1280 from wall plug (power off) 2. Hook-off the phone which is connected to da1280 3. Connect d...
-9- configurations codes **800*1# end of configuration **801*{pin}# registration to base station with {pin} **802*1# fax/modem mode on e **802*0# fax/modem mode off **803*1# internal calls enabled **803*0# internal calls disabled **804*1# end symbol on = # **804*0# end-symbol off **805*1# transparen...
-10- change ex-works-setup method 2: connect da1280 via usb with your pc. A special da1280 app (download from internet) will offer you a comfortable mmi for all settings of da1280. Adapt your setup to your requirements which will be automatically stored on da1280 when closing the app regularly 1. Di...
-11- connectors, led, side key nr element 1 led1 power supply (on/off) 2 led2 dect link quality (3 colors) 3 led3 active call in rep (on/off) 4 side key(reset, special for multicall hs) 5 usb connector (sw upgrade) software upgrade software upgrades for da1280 can be downloaded via usb connector and...
-12- faq: questions and answers please consult also the website of your dealer and/or manufacturer to get updated information and faqs about da1280. Problem root cause remedy no line, no signalling, no dialling possible the analoge terminal is not properly connected to da1280 current line is occupie...
-13- security advices make sure your da1280 is not exposed to heat and interference from electrical devices e.G. Motors and transformers. Da1280 shall be not be placed close to metallic walls. Place da1280 in wall sockets only with leds on top. Protect your da1280 from wet conditions, dust and aggre...
-14- warranty your dealer warrants for 2 years for material and manufacturing quality of the product. Appointed date is the date of buyer‘s receipt. The buyer has the right for repair or replacement. Returned and replaced products will pass its property to the seller. In case of defects buyer has to...
-15- recycling please contact your dealer regarding recycling of your product. In no case get disposed of your product via household garbage. Manual for da1280 dect analogue plug english version 2.0 edition 01 january 2017 editor dosch&amand products gmbh münchen.
-16- ce conformity this product fulfills the requirements of eu rules 2004/108/eg (richtlinie des europäischen parlaments und des rates zur angleichung der rechtsvorschriften der mitgliedstaaten über die elektromagnetische verträglichkeit und zur aufhebung der richtlinie 89/336/ewg), and 2006/95/eg ...
