Da-lite screen company, inc. 3100 north detroit street post office box 137 warsaw, indiana 46581-0137 phone: 574-267-8101 800-622-3737 fax: 574-267-7804 www.Da-lite.Com e-mail: info@da-lite.Com power presentation products the in instruction book for acoustical imager.
1 important safety instructions read first! Important safety precautions! 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Insta...
2 two surround speakers. Two wall-mount brackets. Two shelf stands. Two floor stand adaptors. Three 20' speaker cables for connection to front, left, center and right speakers or to subwoofer when speaker-level connections are used. Two 15' speaker cables for connection from subwoofer to front speak...
3 frame assembly 1. Unpack the frame parts from the carton. Do not unroll the screen surface at this time. 2. To prevent damage to the speaker covers, it is recommended to assemble the screen frame in an upright position as shown in diagram 1. If the frame is too tall to attach the top section, care...
4 speaker placement the acoustical imager is standard as a 5.1 channel system. In 5.1-channel applications, the two surround speakers should be placed slightly behind the listening position and, ideally, should face each other and be at a higher level than the listeners’ ears. If that is not possibl...
Mounting the satellites on optional floor stands note: the supplied floor stand adaptors facilitate installation with a variety of general purpose floor stands available from many manufacturers. Since different stands will have different weight capacities and stability characteristics, it is the cus...
6 mounting options 3. Gently pull the slack out of the wire and screw the adaptor onto the back of the speaker in two places, as shown. 4. The floor stand adaptor screws may be found in hardware bag b. Use the larger screw in the upper screw hole, and the smaller screw in the lower screw hole. 5. Sc...
7 mounting options 8. Holding the satellite speaker with both hands, reinsert the ball portion of the ball and shaft into the attachment plate. 9. Hand-tighten the molded nut while positioning the speaker for the desired orientation. If the molded nut is difficult to tighten by hand, insert the meta...
8 dolby pro logic* (non digital) - line level use this installation method for dolby pro logic applications (not dolby digital, dts or other digital processing), where the receiver/processor is equipped with a subwoofer output, or a volume-controlled preamp (line-) level output: 1. Use rca-type inte...
9 subwoofer operation move the master power switch (marked “power”) to the “•” (on) position to use the sub-woofer. The sub300 subwoofer will automatically turn on or go into standby (sleep) mode when left in the auto mode (“auto/on” switch in the “auto” position). When your receiver or amplifier is...
Troubleshooting symptom 1. No sound from any of the speakers solution (a) check that receiver/amplifier is on and a source is playing. (b) check that the powered subwoofer is plugged in, and it’s power switch is switched on (“•” position). (c) check all wires and connections between receiver/ amplif...
11 printed in u.S.A. 96555 1/05 troubleshooting symptom 4. The system plays at low volumes but shuts off as volume is increased. Solution (a) check all wires and connections between receiver/ amplifier and speakers. Make sure all wires are connected. Make sure none of the speaker wires are frayed, c...
