Instruction book for tensioned large cosmopolitan ® electrol ®.
2 important safety instructions when using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an exte...
3 carefully unpack screen and remove outer wrapping from case. The slat retainer screws must be removed before installation. Use supplied 1/8" nex key to remove silver shipping brackets attached to slat and screen case. Orient the case with the slat down and then remove the screws. The case must rem...
4 tensioned large cosmopolitan ® electrol ® installation for screens without a built-in low voltage control internal wiring has been completed at the factory. Installer must route power to the wall switch and to the junction box located on the left end of the screen case. See wiring diagram below fo...
5 rj-45 receptacle rj-22 output rj-22 inputs up (dry contact) down (dry contact) common (both) bus (bus) 5v (bus) up stop down bus c o m 5 v front of wall switch bus up stop down bus c o m 5v led up limit tactile button down limit tactile button back of wall switch installation for 120v screens rj-2...
6 240v wiring diagram important note: the wall switch is required to make any limit switch adjustments, even if a third party control system is used. Therefore, it is advised to wire the switch or provide a 4-conductor connection that is accessible. Installation for 220/240v screens ilt rj-9 pin-out...
7 troubleshooting symptom cause solution screen will not operate. Motor does not hum. Blown fuse. Replace fuse. Tripped circuit breaker. Reset circuit breaker. No power to operating switch or junction. Check above. Tighten all loose wire connections. Correct any improper connections. Down position c...
Limited one year warranty on da-lite presentation products milestone av technologies llc warrants certain da-lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; pr...
