Da-Lite electrol Instruction Book

Summary of electrol

  • Page 1

    Da-lite screen company, inc. 3100 north detroit street post office box 137 warsaw, indiana 46581-0137 phone: 574-267-8101 800-622-3737 fax: 574-267-7804 www.Da-lite.Com e-mail: info@da-lite.Com instruction book for tensioned professional electrol® the da-lite difference..

  • Page 2: Save These Instructions

    Important safety instructions when using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an extens...

  • Page 3

    Pre-installation 2 1. Carefully unpack screen. 2. Make sure to recheck measurements of screen location before installation. 3. Remove instruction cover plate (fig. 1). Do not remove wrapping paper until screen is installed. 4. Remove the retainer screws from the slat bar before the case has been ins...

  • Page 4

    3 installation 1. Level unit lengthwise with a carpenter’s plum level. Caution! Do not completely seal in unit. Access room must be allowed for motor repair or fabric replacement. 2. Remove shipping brace by removing 2 hex head screws (figure 4). 3. Use supplied 1/8” nex key and a 5/16” wrench to re...

  • Page 5

    4 tensioned professional electrol ® installation ceiling type hanger picture surface picture surface 1" x 3" cleat 2" moulding ceiling mount without hangers screen case is placed flush with the wall and ceiling and held in position by moulding securely attached to the wall. Recessed above ceiling ot...

  • Page 6

    5 tensioned professional electrol ® installation to junction box mounted in screen case, in which internal wiring terminates in white, black, and red leads. In multiple control installations the switch is replaced by the low voltage control, operated from push button stations. Operating switch, swit...

  • Page 7

    6 troubleshooting symptom 1. Screen will not operate. Motor does not hum. 2. Incorrect stopping position in downward direction. 3. Incorrect stopping position in upward direction. 4. Noise. Note: screen will operate with a low pitched hum. 5. Coasting. Cause (a) blown fuse. (b) tripped circuit break...

  • Page 8

    7 printed in u.S.A. 33871 3/13 limited one year warranty on da-lite presentation products da-lite screen company, inc. Warrants its products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original pur...