Instruction book for executive ® electrol ®.
2 pre-installation installation important safety instructions when using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or conta...
3 6. Install electrical hook up that applies to your unit. Unit should be installed by a qualified electrician. Note: must be installed in accordance with the requirements of the local building codes, the canadian electrical code (cec), can/csa c22.1 and the national electric code (nec), nfpa 70. 7....
4 restoring roller wrap executive electrol ® installation caution! Do not attempt to restore a lost wrap by adjusting limit switches! 1. Run fabric all the way down. 2. Run fabric up and stop just before door closes. 3. Remove the access panel (2 screws, fig. 3). 4. Two people with clean hands must ...
5 executive electrol ® installation black red (up) blue black white white re d up limit switch (operated by door) capacitor black (down) down limit switch solenoid switch whit e (common) motor: 120v.60 cycles 1/10 hp intermittent duty with auto-reset thermal protector internal wiring external wiring...
6 symptom cause solution screen will not operate or will not go “down”. Motor does not hum. Blown fuse. Replace fuse. Tripped circuit breaker. Reset circuit breaker. Improper wiring to operating switch. Tighten all loose wire connections. Correct any improper connections. Check for power. “down” pos...
7 symptom cause solution screen will not move “up.” motor does not hum. Motor hums. No power between red and white leads in junction box. Check lvc. See above. Check fuse. Reset circuit breaker. Correct improper wiring. Thermal overload tripped (acts as a breaker). Let motor cool for 15 minutes. Try...
8 symptom cause solution screen jammed. Will not operate, motor hums, door open, closing mechanism detached from door. Closing mechanism detached from door, allowing it to jam into box. After securing fabric to roller, loosen set screws on motor gear and manually rotate solenoid assembly back over t...
9.
10
11.
Limited one year warranty on da-lite presentation products milestone av technologies llc warrants certain da-lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; pr...
