Instruction book for large advantage ® deluxe electrol ®.
2 important safety instructions when using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Close supervision is necessary when any appliance is used by or near children. Do not leave appliance...
3 tools required for installation pre-installation #2 phillips screwdriver 3/4“ open wrench or socket driver 1. Carefully unpack case from shipping crate. 2. Set aside the installation kit. Items inside will be used during installation. 3. Make sure to recheck measurement of case for proper installa...
4 the case has a self-trimming flange around the bottom. Ceiling tiles or drywall may be placed on top of this flange to provide a finished appearance. 1. The case provides multiple attachment points for bolts, cables, or threaded rod. Page 5 shows threaded rod installed. The variable position-mount...
5 installation (suggested) ½" threaded rod (not included) attached to mounting bracket finished ceiling self-trimming flange 9 1/8" 13 1/8" 12 3/16" 11 7/16" 11" door roller screen roller closing door access door audience side self-trimming flange 2 5/16" 10 13/16" variable position mounting bracket...
6 screen and roller assembly installation if your screen was shipped with the motor and roller already installed proceed to step 7. 1. Remove four bolts from ends of door assembly (2 bolts on each end) (fig. 2). This will allow the door assembly to drop open for access to case. For larger sizes, you...
7 surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at da-lite. Should it be necessary to adjust for more or less drop of picture, proceed in the following manner: note: use a screw driver or 5/32" allen wrench to make adjus...
8 120v wiring diagram note: 20-24 awg wire recommended for connecting wall switch to dual motor controller. Caution: do not use 3-position high voltage rocker switch with this unit! This will damage the low voltage control board. Attention: n'utilisez pas un interrupteur à bascule à 3 positions pour...
9 240v wiring diagram note: 20-24 awg wire recommended for connecting wall switch to dual motor controller. Caution: do not use 3-position high voltage rocker switch with this unit! This will damage the low voltage control board. Attention: n'utilisez pas un interrupteur à bascule à 3 positions pour...
10 troubleshooting symptom cause solution screen will not operate or will not go “down”. Motor does not hum. Motor hums. Incorrect line voltage. Verify 115-125v (or 220-240v). If insufficient voltage, rewire incoming electric line. Blown facility fuse. Replace facility fuse. Tripped facility circuit...
11 troubleshooting (continued) symptom cause solution door will not open. Spring has an obstruction not allowing door to open.. Check installation to free door. Clear any foreign substance from spring. No power. See above. Door does not close. Mis-adjusted door motor limit. Adjust door motor limit. ...
Limited one year warranty on da-lite presentation products milestone av technologies llc warrants certain da-lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; pr...
