Instruction book for multi-mask imager.
2 unpacking and unrolling the screen the viewing side of the screen surface is rolled to the inside. The screen surface is rolled lengthwise. 1. Remove screen from packaging. 2. On a clean floor, unroll the screen surface viewing side up. 3. Allow the paper to unroll between backside of the screen s...
3 figure 4 attaching the screen surface to frame 1. Place the frame over the screen surface. 2. While lifting the frame with one hand, snap the screen surface onto the frame. Gently allow the screen to stretch onto snaps. See figure 4. Attach the snaps on the top corners and top horizontal first, li...
4 installing the high voltage switch control (standard) three standard 3-position wall switches are supplied. The high-voltage control is connected to the electrical source. It alternates directions of mask motion by means of a hot lead, using the 3-position switches. Multi-mask imager installation ...
5 6 figure 7 side cover opening side attach the wall brackets to the wall using appropriate fasteners at previously marked locations. Attach the side covers to the frame by sliding the bolts on the side cover tube into the openings on the top and bottom brackets. See figure 7. When you lower or retr...
6 1 2 3 4 5 6 modifying the extension of the mask you can increase the extension of a mask up to 3" past the factory preset stop, or you can decrease the extension by approximately 4-6" from the factory preset stop. Do not attempt to modify a mask extension beyond these recommended amounts. The limi...
7 troubleshooting refer to the following guidelines if you encounter a difficulty in the operation of your da-lite multi-mask imager screen. Problems related to electrical or motor function may require a qualified service person or electrician. Should you have a problem that is not addressed here, c...
Limited one year warranty on da-lite presentation products milestone av technologies llc warrants certain da-lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; pr...
