Da-lite screen company, inc. 3100 north detroit street post office box 137 warsaw, indiana 46581-0137 phone: 574-267-8101 800-622-3737 fax: 574-267-7804 www.Da-lite.Com e-mail: info@da-lite.Com power presentation products the in instruction book for pro imager.
Important safety instructions when using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an extens...
Frame assembly 2 tools required for assembly 5/16" socket or wrench carpenters level tape measure 1. Unpack frame pieces and lay them face down on the floor. The top frame has the roller and motor assembly attached to it. The side frames are the two short pieces. 2. Attach the side frame pieces to t...
3 1. To install the pro imager over a da-lite perm-wall screen you will need to place the supplied wooden spacers between the screen and the wall. Da-snap and imager screens do not require any spacers. 2. Refer to figure 3 for hanger bracket location. Dimension a will vary depending on the type of s...
Pro imager installation d o w n r e d u p b l a c k c o m m o n w h it e black with yellow black white red up down rocker switch ac common ac hot operating switch, switch box, and plate furnished with screen. (spdt with center off) 120v. 60-hz 2.5 max. Amp to motor in multiple control installations ...
5 adjustment masking travel is stopped automatically in the up and down positions by limit switches that are properly adjusted at the factory. Should it be necessary to adjust the stop positions, proceed in the following manner using a small flat screwdriver or a 5/32" allen wrench. Access to the sw...
6 troubleshooting symptom 1. Screen will not operate or will not go “down” . Motor does not hum. Motor hums. 2. Screen will not move “up”. Motor does not hum. Motor hums. 3. Noise. Note: screen will operate with a low-pitched hum. 4. Coasting. 5. Roller displaced from mounting brackets. 6. Mask hang...
Printed in u.S.A. 82391 rev. 7/09 7.
