Da-Lite TENSIONED CONTOUR ELECTROL Instruction Manual

Other manuals for TENSIONED CONTOUR ELECTROL: Instruction Book, Instruction Book

Summary of TENSIONED CONTOUR ELECTROL

  • Page 1

    Da-lite screen company, inc. 3100 north detroit street post office box 137 warsaw, indiana 46581-0137 phone: 574-267-8101 800-622-3737 fax: 574-267-7804 toll free fax: 877-325-4832 www.Da-lite.Com e-mail: info@da-lite.Com instruction book for tensioned contour® electrol® the da-lite difference..

  • Page 2: Save These Instructions

    1 important safety instructions when using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an exte...

  • Page 3

    2 installation 1/4 x 5/8" flat head screw ceiling hook bracket ceiling mount bracket 1/4 x 5/8" flat head screw figure 2 figure 3 figure 1 5-11/16" 2-5/16" 2-9/16" case hook wall mount bracket 6-3/8" stop screw carefully unpack screen and remove outer wrapping from case. Remove the retaining screws ...

  • Page 4

    3 electrical installation internal wiring has been completed at the factory. Installer must route power to the wall switch and to the junction box located on the left end of the screen case. Standard installation is for a single 120vac or 240vac wall switch to control the screen. Optional control un...

  • Page 5

    4 tensioned contour ® electrol ® installation up off down this switch can not be used with lvc. 120v wiring diagram for standard wall switch 240v wiring diagram with optional built-in video projector interface spdt switch with center off ac (common) ac hot 120vac 60hz 1 amp black/ yellow black red w...

  • Page 6

    5 tensioned contour ® electrol ® installation low-voltage wall switch optional ir and rf remote control motor blue (common) brown (hot) green ground to case 240vac 50hz 240v wiring diagram with optional built-in low voltage control rj9 up stop down ground–must be connected to building ground rj9 gre...

  • Page 7

    Troubleshooting symptom 1. Screen will not operate. Motor does not hum. 2. Incorrect stopping position in downward direction. 3. Incorrect stopping position in upward direction. 4. Noise. Note: screen will operate with a low pitched hum. 5. Coasting. Cause (a) incorrect line voltage. (b) blown fuse....

  • Page 8

    Printed in u.S.A. 88820 rev. 3/11 7 limited one year warranty on da-lite presentation products da-lite screen company, inc. Warrants its products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the origina...