Da-lite screen company, inc. 3100 north detroit street post office box 137 warsaw, indiana 46581-0137 phone: 574-267-8101 800-622-3737 fax: 574-267-7804 toll free fax: 877-325-4832 www.Da-lite.Com e-mail: info@da-lite.Com power presentation products the in instruction book for tensioned horizon elec...
Pre-installation 1 1. Carefully unpack screen and remove outer wrapping from case. 2. Make sure to recheck measurements of screen location before installation. Drywall screw access panel machine screw picture surface screen motor #1 slats mask motor #2 junction box bus interface unit control wires h...
Screen operation the horizon screen has been preset to four different formats. The screen can be set to any format by simply pressing the corresponding button on the six-button switch. Below is a list of each button function. Important. When operating the switch, press and release the buttons. Do no...
3 screen adjustment screen adjustment (motor 1) 1. Make sure the power is disconnected to the screen before starting. 2. Remove the cover plate from the wall switch, and then remove the switch from the box. 3. Unplug the t6 cable marked motor 2 from the t6 adapter. 4. Locate the bus interface contro...
4 240v wiring diagram 120v wiring diagram motor 2 120vac-24vdc transformer momentary dry contact inputs 6-button wall switch t6 1 t6 t4 motor 1 bus interface unit motor 2 receptacle for main power connection and 24vdc transformer plug in 120vac 60 hz external wiring t6 = 6 conductor telephone wire t...
Suggested methods of installation offset mounting, recessed above ceiling. For plaster, dry wall, tile or paneling. Bottom of case painted same finish as ceiling. Offset mounting, recessed above ceiling. May be adapted for 3/4" ceiling, but cut to 1/4" thick under screen case and panel. Offset mount...
Troubleshooting symptom 1. Screen or mask will not operate. Motor does not hum. Motor hums. Cause (a) blown facility fuse. (b) tripped facility circuit breaker. (c) no power to receptacle in junction box. (d) no power to bus interface unit. (e) loose control wire connections power at junction box (f...
7 printed in u.S.A. 83503 rev. 12/07.
