Da-Lite Tensioned Large Cosmopolitan Electrol Instruction Book

Other manuals for Tensioned Large Cosmopolitan Electrol: Instruction Book, Instruction Book

Summary of Tensioned Large Cosmopolitan Electrol

  • Page 1

    Da-lite screen company, inc. 3100 north detroit street post office box 137 warsaw, indiana 46581-0137 phone: 574-267-8101 800-622-3737 fax: 574-267-7804 www.Da-lite.Com e-mail: info@da-lite.Com instruction book for tensioned large cosmopolitan® electrol® 9'x12', 180" diagonal and larger sizes the da...

  • Page 2: Save These Instructions

    Important safety instructions when using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an extens...

  • Page 3

    Carefully unpack screen and remove outer wrapping from case. The slat retainer screws must be removed before installation. The slotted 1/4" hex screws fasten through the back of the case (at the bottom) into the slat bar. Orient the case with the slat down and then remove the screws. The case must r...

  • Page 4

    Tensioned cosmopolitan ® electrol ® installation for screens without a built-in low voltage control internal wiring has been completed at the factory. Installer must route power to the wall switch and to the junction box located on the left end of the screen case. See wiring diagram below for wire c...

  • Page 5

    4 setting the up limit position caution: do not allow the slat bar to wrap over the top of the roller when the screen is rolling into the case. The screen could be damaged. Screen travels into case too far: turn the up limit switch screw clockwise to decrease the amount of travel. Run the screen up ...

  • Page 6

    5 tensioned cosmopolitan ® electrol ® installation for screens with a built-in low voltage control screen adjustment for screens with a built-in low voltage control 1. Remove the cover plate from the 3-button wall switch and remove the switch from the junction box. 2. Locate small 3-position switch ...

  • Page 7

    Troubleshooting symptom 1. Screen will not operate. Motor does not hum. 2. Incorrect stopping position in downward direction. 3. Incorrect stopping position in upward direction. 4. Noise. Note: screen will operate with a low pitched hum. 5. Coasting. Cause (a) blown fuse. (b) tripped circuit breaker...

  • Page 8

    Limited one year warranty on da-lite presentation products da-lite screen company, inc. Warrants its products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are proper...