Instruction book for utb contour.
2 tools required for installation included hardware large wall bracket (47”) (1) screens under 104" in viewing width (2) screens 104" and over in viewing width phillips screwdriver tape measure pencil small bottom wall bracket (8”) (1) screens under 104" in viewing width large bottom wall bracket (4...
3 1. Create a clean work area for assembly using a soft clean material. This will protect the inner frame and ensure a clean projection surface. 2. Unwrap frame pieces. Assemble inner frame pieces on the work area. 3. Slide inner frame pieces together at corners. Secure inner frame pieces with (12) ...
4 1. Position outer bezel pieces on all sides (figure 3a). Gently lift and slide each outer bezel piece around the inner frame and viewing surface assembly (figure 3b). 2. Align corners and insert one 8–32 x 3/8" screw in each corner to attach the outer bezel onto the inner frame assembly (figure 4)...
5 outer bezel assembly (continued) b. For screens 104” wide viewable and over, attach (2) frame brackets if your screen is 104" or over in viewing area width (figure 7). 5. Insert 8-32 x 1/2" zinc plated fillister screw into frame bracket(s) (figure 6 or 7). Rotate four or five turns only. Figure 6 ...
6 1. Secure the large top wall bracket to wall studs at the desired height. Make sure the bracket is level. The top of the screen will be 2–1/4" above the top of the edge of this wall bracket when mounted. You will need at least a 3" clearance above the bracket to hang the screen (figure 8). 2. To i...
7 1. Secure the (2) large top wall bracket to wall studs at the desired height. Make sure the brackets are level. The top of the screen will be 2–1/4" above the top of the edge of this wall bracket when mounted. You will need at least a 3" clearance above the brackets to hang the screen (figure 9). ...
Limited one year warranty on da-lite presentation products milestone av technologies llc warrants certain da-lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; pr...
