Instruction book for viewshare tensioned advantage electrol.
2 tools required for installation 1. Hang case and attach to support structure with bolts. See suggested methods of installation. 2. Tighten bolts until trim flange is flush with ceiling. Note: for proper operation, screen assembly must be level after installation. 3. Remove 2 screws to open junctio...
3 suggested methods of installation 3/8" threaded rod (not supplied) hanger bracket electrical junction box motor end variable position mounting bracket audience side 6 7/16" 6 1/16" 7 3/4" 3/8" threaded rod (not included) attached to mounting bracket self-trimming flange finished ceiling 7 3/4" 7 3...
4 screen adjustment for 120v screens 1. Remove the cover plate from the 3-button wall switch and remove the switch from the junction box. 2. Locate small 3-position switch on back of wall switch. See figure 5 for 120v screens or figure 8 for 220/240v screens. 3. To adjust the down limit switch, slid...
5 rj-45 receptacle rj-25 output rj-25 inputs up (dry contact) down (dry contact) common (both) bus (bus) 5v (bus) up stop down bus c o m 5 v front of wall switch bus up stop down bus c o m 5v led up limit tactile button down limit tactile button back of wall switch wall switch installation for 120v ...
6 rj-45 receptacle rj-25 output rj-25 inputs up (dry contact) down (dry contact) common (both) bus (bus) 5v (bus) up stop down bus c o m 5 v front of wall switch bus up stop down bus c o m 5v led up limit tactile button down limit tactile button back of wall switch up stop down bus c o m 5v power in...
7 240v wiring diagram important note: the wall switch is required to make any limit switch adjustments, even if a third party control system is used. Therefore, it is advised to wire the switch or provide a 4-conductor connection that is accessible. Wall switch installation for 220/240v screens ilt ...
8 camera and speakerphone installation the following components are necessary for camera and speakerphone installation. Included: • local cat5 to usb extender with power supply • 6’ usb cable • usb speakerphone • powered usb hub you also will need enough cat5 or cat5e network cable to run from the v...
9 camera and speakerphone installation (continued) camera and speakerphone setup you are now ready to run the initial camera setup. The computer will recognize the camera as a new component and load the appropriate drivers. This can take up to several minutes and you may need to follow on-screen ins...
10 troubleshooting visit www.Da -lite.Com/products/tutorials.Php to find installation and troubleshooting tutorials. You will also find a link to live chat for interactive support. You can contact us by email at info@da-lite.Com or by phone at 800.622.3737 or 574.267.8101 with any additional trouble...
11.
Limited warranty – viewshare products milestone av technologies llc warrants its da-lite branded viewshare products to the original purchaser only, to be free from defects in materials and workmanship in accordance with the following warranty term: a period of five (5) years for the advantage screen...
