DABmotion AN3012DAB Installation Manual

Summary of AN3012DAB

  • Page 1

    An3012dab glass-mount dab antenna installation guide.

  • Page 2: Table Of Content

    An3012dab installation guide table of content introduction .................................................................................................................. 1 overview ......................................................................................................................

  • Page 3

    An3012dab installation guide -1- introduction this installation guide shows you how to install the glass-mount dab antenna in your car to work with the in-car dab receiver and receive digital radio transmissions. Overview warning: 1. Please read the antenna installation section carefully prior to th...

  • Page 4

    An3012dab installation guide -2- antenna installation the an3012dab antenna can be installed on either side of the front windshield by rotating the dab antenna and flipping the antenna cable around: left mount right mount 1. Pre-installation the glass-mount antenna must be placed on the top corner a...

  • Page 5: Left

    An3012dab installation guide -3- 1.3 a pillar and windshield the windshield usually has a black enamel band along the edges that contains a border of dots and a black-shade area, the signal booster is to be installed next to the dotted area along the side of the windshield. Open the a pillar cover; ...

  • Page 6

    An3012dab installation guide -4- 2. Permanent installation you should complete reviewing the pre-installation section and fit the antenna before you begin the permanent installation of this dab antenna. 2.1 clean the windshield ensure the chosen antenna location on the windshield is clean and free o...

  • Page 7

    An3012dab installation guide -5- fiber; also peel off a small portion of the adhesive separator on the copper strip. Then, press and bond the signal booster to the marked location from pre-installation and on the inside of the front windshield. Ensure that the signal booster, copper strip, and anten...

  • Page 8

    Af2-p_v1.0_1403 specification frequency range l-band: 1450 - 1490 mhz band iii: 170 - 250 mhz vswr l-band: band iii: amplification l-band: > 30.6 dbi band iii: > 21 dbi signal-to-noise ratio 1.18 db dc voltage +12 v dc current input impedance 50 ohm dab antenna dimension antenna: 185(l) x 43(w) mm, ...