1. DL manuals
  2. Dacor
  3. Refrigerator
  4. 100500
  5. Installation Instructions Manual

Dacor 100500 Installation Instructions Manual - Able

Manual is about: Dacor Built-in Refrigerator Installation Instructions

Summary of 100500

  • Page 1

    Part no. 100500 rev. A i nstallation i nstructions b uilt -i n r efrigerators.

  • Page 3: Able

    Refrigerator safety .......................................................................1 design specifications ...............................................................2-6 product dimensions ....................................................................2 door swing dimensions ..........

  • Page 4: Esign

    D oor s wing d imensions the area to the left and the right of the appliance must permit both doors to open to a minimum of 90°. Allow a minimum of 2 1/2” (64mm) space between the side of the refrigerator doors and a corner wall. Note: more clearance may be required if using an overlay panel or cust...

  • Page 5: Esign

    H (a) grille panel h w (c) non-dispenser freezer panel w (d) refrigerator panel w h w h1 h2 w1 w2 (b) dispenser freezer panel d esign s pecifications c ustom o verlay p anels the decorator panels for overlay models cover the door trim for an attractive, seamless look that flows into the overall desi...

  • Page 6: Esign

    Overlay panel specifications (see illustrations on page 3.) 42-inch model 48-inch model backer panel (a) grille panel w width 40 1/4” (1022mm) 46 1/4” (1175mm) h height 8 3/4” (222mm) 8 3/4” (222mm) (b) freezer dispenser panel w width 16 1/4” (413mm) 18 1/2” (470mm) w1 width 2” (51mm) 2” (51mm) w2 w...

  • Page 7: Esign

    D esign s pecifications custom toe kickplate specifications if using custom toe kickplate with your dacor ® built-in refrigerator, refer to the following specifications. “c” 3" 3 3/4" r. 1/2" non-dispenser 2 3/16" typ 7/8" 5/16" 4 13/16" 5 5/8" 1 1/8" typ 6 1/4" 15/16" typ panel thicker than 3/16" c...

  • Page 8: Esign

    D esign s pecifications 0" 3/4" overlay panel 1/4" 90˚ door opening (top view) 23 7/8" to rear of cabinet cabinet trim door open @ 90˚ door closed 1/2" 3/4" 1" 1 1/4" 1 1/4" 1" 3/4" 1/2" 1/4" 0" 1 1/2" 1 3/4" 2" 2 1/4" 2 1/2" 2 3/4" 3" 3 1/4" 3 1/2" 90° door stop both doors are designed to open 135°...

  • Page 9: Nstallation

    I nstallation s pecifications t ools and p arts important: ◊ installer: leave these installation instructions with the homeowner. ◊ homeowner: keep these installation instructions for future reference. Save these installation instructions for the local electrical inspector’s use. Tools needed: make ...

  • Page 10: Nstallation

    Rough-in dimensions ◊ the solid sofit or ceiling should be within 1” (25mm) above the refrigerator. If the solid sofit is higher than 1” (25mm) or one is not available, then the refrigerator must be braced to prevent tipping during use. If the anti-tip blocking is need. (see “anti-tip blocking” on p...

  • Page 11: Nstallation

    I nstallation i nstructions u npack r efrigerator warning tip over hazard – refrigerator is top heavy and tips easily when not completely installed, keep doors taped closed until refrigerator is completely installed. Use two or more people to move and install refrigerator. Failure to do so can resul...

  • Page 12: Nstallation

    0 i nstallation i nstructions w ater l ine c onnection p lug in r efrigerator m ove u nit to f inal p osition important: to prevent floor damage, make sure levelers are raised (not touching the floor) and the unit is on rollers before moving. ◊ place top of cardboard carton or plywood under refriger...

  • Page 13: Nstallation

    I nstallation i nstructions i nstall c ustom p anels panel installation before you begin installing panels, refer to the “custom panel specifications” for overlay models and verify that you are working with the panel design called for in your installation. If you have chosen the stainless steel desi...

  • Page 14: Nstallation

    7. Remove the four #15 torx plastic collar screws from the fountain/escutcheon collar. 8. Place the fountain/ escutcheon collar onto the backer panel. Use tape to hold in place. 9. Open the freezer door and slide panel onto the door. 10. The holes in the fountain/escutcheon collar should line up wit...

  • Page 15: Nstallation

    I nstallation i nstructions side panel installation if using side panels with the dacor ® built-in refrigerator, they will need to be 1/4-inch thick. Slide the panel into position and secure with screws indicated by the shaded area. A 3/16-inch spacer is required between the cabinet and side panel. ...

  • Page 16: Nstallation

    The importance of the proper installation of your dacor built-in refrigerator cannot be overemphasized. Proper installation is the responsibility of the homeowner. Important: to ensure a safe and proper installation, the following checklist should be competed by the installer to ensure that no part ...

  • Page 17: Otes

    N otes.

  • Page 18: Otes

    N otes.

  • Page 20

    Web site: www.Dacor.Com phone: (800) 793-0093 the information and images in this book are the copyright property of distinctive appliances, inc. Neither this book nor any information or images contained herein may be copied or used in whole or in part without the express written permission of distin...