Dacor AEGR30 Instructions

Grill Models: AEGR30, AEGR3648, 

AGDRT14 and AGRG14

INSTRUCTIONS

Cooktop and Range Models: DR30D, DRT304S, EG366, EG486 

ER30D, ER30DSR, ER30G, ER30GI, ER36D and ER48D

Part No. 102331 Rev. F

WARNING: Do not touch the grill when hot.

WARNING: Do not use water on grease fires. A violent steam explosion may result. Smother any 

flames with a lid, cookie sheet or flat tray. Use baking soda or a foam extinguisher to extinguish flam-

ing grease. Be careful to avoid getting burned.

WARNING: Non-stick coatings, when heated, can be harmful to birds. Remove birds to a separate, 

well-ventilated room during cooking.

CAUTION: Place the grill only in the position shown in these instructions. Do not turn the burners 

under the grill higher than the 

MAX GRIDDLE setting. Setting the burner flames too high or putting 

the grill in the wrong position may damage it permanently. Some appliances do not come with knobs 

marked with the 

MAX GRIDDLE setting. The grill kit for these appliances comes with MAX GRIDDLE 

knobs that must be installed prior to use.

(Cooktop/Range Models DR30D, DRT304S, ER30G and ER30GI Only)

Grills for the above listed cooktops/ranges come with knobs with the words 

MAX GRIDDLE on them. Install them 

before using the grill to prevent damage. All other models come with the 

MAX GRIDDLE knobs already installed.

CAUTION: Putting the knobs in the wrong position may result in damage to the grill.

STEP 1

Remove the existing two knobs on the right side of the control panel. Grasp each one and pull straight 

back. Leave the other two knobs in place.

STEP 2

  Put the new knobs from the kit, with the words MAX GRIDDLE on them, on the valve shafts in place 

of the knobs removed in step 1. When installing the knobs, align the “D-shaped” opening on the back 

of the knob with the end of the valve shaft. Carefully push in on each knob until it stops. The old knobs 

may be discarded.

 DRT304 Cooktop

DR30D Range

ER30G[I] Range

Knob Installation