Dacor AOCTK27 Installation Instructions

Other manuals for AOCTK27: Planning Manual, Planning Manual

Summary of AOCTK27

  • Page 1

    1 for dacor built-in kit model aoctk27 or aoctk30 this kit is ul approved to allow certain microwave ovens to be installed above certain conventional/convection wall ovens. Please see the operation manual regarding built-in applications. If your lower conventional oven is not listed in the operation...

  • Page 2

    Figure 1 figure 2 figure 3 step 1 cabinet or wall opening cabinet or wall opening provide an opening in the wall or cabinet as indicated on fi gure 1. The depth should be a minimum of 24". The fl oor of the opening should be constructed of plywood strong enough to support the weight of the oven (about...

  • Page 3

    3 figure 4 figure 5 figure 6 figure 7 step 3 cord box 1. Plug the oven electrical cord into the cord box receptacle and roll the remaining part of the cord into the cord box as shown in figure 6-a. 2. Remove screw #2 from lower left rear of the oven. Insert right fl ange of the cord box into hold lip...

  • Page 4

    Step 5 frame installation attach bottom duct with two screws-c. Attach built-in trim kit frame with four screws-b. See fi gure 8. Over oven installation over warming oven installation dacor inc. 1440 bridge gate drive • diamond bar, ca 91765 1-800-793-0093 • www.Dacor.Com tinseb423mrr0 4 figure 8 epi...