1. DL manuals
  2. Dacor
  3. Oven
  4. Discovery EO Series
  5. Installation Instructions Manual

Dacor Discovery EO Series Installation Instructions Manual

Summary of Discovery EO Series

  • Page 1

    Installation instructions discovery wall oven eo, moh and mov series part no. 65433 rev. L.

  • Page 2

    All specifications are subject to change without notice. Dacor ® assumes no liability for changes to specifications. © 2007 dacor, all rights reserved..

  • Page 3

    1 planning the installation ................................................... 6 selecting the location ...................................................... 6 cabinet cutout ................................................................. 6 electrical specifications ................................

  • Page 4

    2 important safety instructions • read the accompanying use and care manual before operating this appliance. • keep packaging materials away from children. Plastic sheets and bags can cause suffocation. • if you receive a damaged product, immediately con- tact your dealer or builder. Do not install ...

  • Page 5

    3 if you need help... If you have questions or problems with installation, contact your dacor dealer or the dacor customer service team. For repairs to dacor appliances under warranty call the dacor distinctive service line. Whenever you call, have the model and serial number of the appliance ready....

  • Page 6

    4 product specifications model number a b c d e f g h eo127 27” (68.6 cm) 27 15/16” (71.0 cm) 23 3/8” (59.4 cm) 2 5/16” (5.9 cm) 7 3/8” (18.7 cm) 6 3/8” (16.2 cm) 27 3/8” (69.5 cm) 25 3/8” (64.4 cm) moh127 mov127 eo130 30” (76.2 cm) 28 3/8” (72.1 cm) moh130 mov130 eo227 27” (68.6 cm) 51 1/16” (129.7...

  • Page 7

    5 g d e f c 66” (167.6 cm) flexible conduit a b 1 1/4” (3.2 cm) h chassis notch side view control panel front top of chassis l k top of chassis utility cutout j g d e f c 66” (167.6 cm) flexible conduit a b 1 1/4” (3.2 cm) h chassis notch side view control panel front top of chassis top of chassis u...

  • Page 8

    6 planning the installation selecting the location • carefully check the location where the oven is to be installed. The oven should be placed for convenient access, but away from drafts that may be caused by doors, windows, and heating, ventilation and air condi- tioning outlets. • make certain tha...

  • Page 9

    7 planning the installation alternate electrical locations 4“ (10.2 cm) min. Between cutout recommended electrical location 4“ typical toe kick (shown) 1“ (2.5 cm) min. To combustibles a b 3/4” (1.9 cm) support platform a b 3/4” (1.9 cm) support platform 36” typical (91.4 cm) 1 1/2” (3.8 cm) typical...

  • Page 10

    8 planning the installation cabinet cutout (continued) support platform warning the top surface of the support platform must be installed flush with the cutout in the front of the cabinet or wall and any trim. Failure to install the platform properly may cause the exhaust vent to deform and/or becom...

  • Page 11

    9 planning the installation installation instructions electrical specifications important • preheat times and cavity temperature recovery times will be increased slightly if operating on less than a 240 vac circuit. • this appliance is provided with electrical connection leads in a flexible metal co...

  • Page 12

    10 1. Before proceeding, turn off power to the circuit to which the oven will be connected at the circuit breaker or fuse box. 2. Position the oven directly in front of the cabinet cutout. 3. Feed the appliance conduit into the electrical junction box and attach it using a ul approved strain relief....

  • Page 13

    11 installation instructions connecting to a three (3) wire electrical system - where local codes permit warning do not connect the green appliance conduit wire to the neutral (white) junction box wire unless local building codes permit. 1. Separate the wires coming out of the appliance conduit. 2. ...

  • Page 14

    12 installation instructions three (3) wire connection with external ground conduit to wall oven cable from circuit breaker panel or fuse box wire nut (4 places) junction box separate no. 10 min. Copper grounding wire clamp must be tight on pipe connecting to a three (3) wire electrical system with ...

  • Page 15

    13 3. Raise the door so that it is at a 15° angle from the front of the oven. Hold the door with one hand on each side. Lift the door up and out. Install the oven in the cabinet warning • use an appliance dolly to move the appliance when installing it or removing it from the wall for service. Use of...

  • Page 16

    14 installation instructions install exhaust deflector caution install the exhaust deflector before installing the oven door(s). Attach the exhaust deflector to the front of the oven. It attaches to the oven just below the oven chamber in the door jam. On a double oven, the exhaust deflector is moun...

  • Page 17

    15 installation instructions installation checklist warning • to ensure a safe and proper installation, the follow- ing checklist should be completed by the installer to ensure that no part of the installation has been over- looked. • proper installation is the responsibility of the home- owner. The...

  • Page 18

    16 notes.

  • Page 20

    Dacor●600antonblvd.Suite1000costamesa,ca92626●phone:(800)793-0093●fax:(626)403-3130●www.Dacor.Com.