Dacor Distinctive DTCT304G Installation Instructions Manual - page 13
11
Installation Instructions
Correct Flame Appearance
Installation Checklist
WARNING
To ensure a safe and proper installation, the following
checklist should be completed by the installer to ensure
that no part of the installation has been overlooked.
Proper installation is the responsibility of the homeowner.
The importance of proper installation of your Dacor
cooktop cannot be overemphasized.
□
Is the electrical outlet for the cooktop grounded and
located according to these instructions and in accor-
dance with all applicable electrical codes?
See page 4.
□
Is the gas service for the cooktop located and installed
according to these instructions and in accordance with
all applicable codes? See page 4.
□
Has the gas supply inlet pressure been measured to
ensure that it does not exceed the maximums stated in
these instructions? See page 4.
□
Is the cooktop secured using the provided hold-down
brackets? See page 9.
□
Is the cooktop connected to the gas supply according
to these instructions and in accordance with all appli-
cable codes? Did the installer check the gas supply for
leaks? See page 9.
□
Are the burners and grates properly installed according
to these instructions? See page 10.
□
Has proper operation been verified?
□
Has the warranty been activated on-line or the warranty
card filled out completely and mailed?
Verifying the Correct Setup
• Once the burner lights, rotate the control knob from
HIGH to LOW to adjust the flame height.
• When the unit is installed correctly, the flame burns
steadily and has a sharp, blue inner cone that var-
ies in length proportional to the burner size. The
flame will be reduced by the Smart Flame™ feature
under the grate fingers to increase grate life.
NOTE: If the cooktop does not function properly, follow
these troubleshooting steps:
• Verify that power and gas are supplied to the cooktop.
• Check to make sure that the power plug is connected
to the electrical outlet and that power is turned on at
the circuit breaker or fuse box.
• Check to make sure that the burners are correctly
seated.
• If the burner continues to spark after ignition stopping,
have a licensed electrician check the electrical outlet
for proper grounding or reversed polarity.
• Repeat the above burner ignition test (step 8).
• If the appliance still does not work, contact Dacor
Distinctive Service at (800) 793-0093 ex. 2822. Do not
attempt to repair the appliance yourself. If you need
service, be sure to have the model and serial numbers
available when you call. See inside cover for location.
Dacor is not responsible for the cost of correcting problems
caused by a faulty installation.