Dacor DYF42BNDI Installation Instructions Manual

Other manuals for DYF42BNDI: Dimensions, Use And Care Manual
Manual is about: Installation Instructions

Summary of DYF42BNDI

  • Page 1

    Part no. 107310 rev. A/w10565752 discovery ™ built-in refrigerator 42 and 48 inch models: dyf42bndi and dyf48bndi installation instructions.

  • Page 2

    © 2013 dacor, all rights reserved. All specifications subject to change without notice. Dacor assumes no liability for changes to specifications. Table of contents customer service information if you have questions or problems with installation, contact your dacor ® dealer or the dacor customer serv...

  • Page 3: Danger

    1 refrigerator safety you can be killed or seriously injured if you don't immediately you can be killed or seriously injured if you don't follow all safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructio...

  • Page 4: Warning

    2 location requirements your dacor refrigerator can be recessed in an opening between cabinets or installed at the end of a cabinet run using a side panel to enclose the refrigerator. Important: observe all governing codes and ordinances. It is recommended that you do not install the refrigerator ne...

  • Page 5: Warning

    3 electrical requirements before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection. Recommended grounding method a 115 volt, 60 hz., ac only 15 or 20 amp. Fused, grounded electrical supply is required. It is recommended that a ...

  • Page 6

    4 installation requirements if the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kpa): check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if necessary. Allow the storage tank on the reverse osmosis system to refi...

  • Page 7

    5 product dimensions side view: the depth from the front of the top grille to the back of the refrigerator cabinet is 25 ³⁄ 8 ” (64.5 cm). The power cord is 84” (213.3 cm) long. Height dimensions are shown with leveling legs extended ¹⁄ 8 ” (3.2 mm) below the rollers. * when the leveling legs are fu...

  • Page 8

    6 130 ˚ 130 ˚ 90 ˚ 90 ˚ 110 ˚ 110 ˚ 51 3 ⁄ 8 " (130.5 cm) 44" (111.8 cm) 19 1 ⁄ 4 " (48.9 cm) 14 3 ⁄ 8 " (36.5 cm) 39" (99.1 cm) 43 7 ⁄ 8 " (111.4 cm) door swing dimensions the location must permit both doors to open to a minimum of 90°. Allow 4½” (11.4 cm) minimum space between the side of the refr...

  • Page 9

    7 installation requirements spacer panel ¼" (6.35 mm) ¾" (1.9 cm) 1" (2.5 cm) ½" (1.3 cm) 1" 1 ¼" 1 ½" 1" (2.5 cm) 1 ¼ (3.2 cm) " 1½ (3.8 cm) " refrigerator side trim door hinge ba cker p anel overl ay p anel (2.5 cm) (3.2 cm) (3.8 cm) (1.3 cm) cabinetry (1.9 cm) ½" ¾" the custom door panels and adj...

  • Page 10

    8 installation requirements refrigerator side trim door ba cker p anel overl ay p anel hinge spacer panel cabinetry 90˚ door stop position ¼" (6.35 mm) ¾" (1.9 cm) ¾" (1.9 cm) 1" (2.5 cm) ½" (1.3 cm) ½" (1.3 cm) 1" (2.5 cm) 1" (2.5 cm) 1 ¼ (3.2 cm) 1½ (3.8 cm) (1.3 cm) (1.9 cm) ½" ¾" door panels and...

  • Page 11

    9 installation requirements the custom overlay panels allow you to blend the exterior of your refrigerator into the overall kitchen décor, and to use custom handles for additional design flexibility. The custom panels must have backer panels attached in order to mount them to the refrigerator. It is...

  • Page 12

    10 handles • before installing a custom panel assembly, you must install the custom handle hardware. The handle and handle mounting hardware are not provided with the refrigerator. • dacor recommends handles with larger d-style pulls. Any handle designed for use with an appliance should produce sati...

  • Page 13: Warning

    11 unpack refrigerator important: if you receive a damaged product, immediately contact your dealer or builder. Do not install or use a damaged appliance. Do not remove the film on the outside until the refrigerator is in its operating position. All four leveling legs must contact the floor to suppo...

  • Page 14

    12 install anti-tip boards important: to avoid tipping during use, the solid soffit must be within 1” (2.5 cm) maximum above the refrigerator. If the solid soffit is higher than 1” (2.5 cm) or one is not available, then the refrigerator must be braced. It is recommended that board(s) be installed be...

  • Page 15: Warning

    13 installation instructions connect water supply (cont.) connecting to refrigerator parts supplied: ¼” to ¼” (6.4 mm to 6.4 mm) male to male coupling. Note: the flexible codes approved water supply line can connect to the supply valve through the floor or through the side cabinets, as indicated by ...

  • Page 16: Warning

    14 warning tip over hazard refrigerator is top heavy and tips easily when not completely installed. Keep doors taped closed until refrigerator is completely installed. Use two or more people to move and install refrigerator. Failure to do so can result in death or serious injury. 3. Continue adjusti...

  • Page 17

    15 installation instructions important: install the custom handles prior to installing the panels on the refrigerator. Create custom door overlay panels according to the specifications in the custom panels and handles section. Dacor is not responsible for customer installed molding or decorative pan...

  • Page 18

    16 5. After adjusting, check the doors to make sure they are even at the top and bottom. If the doors are not even, continue to turn the bushing to adjust the door height. 6. Replace the locking plate. 7. Turn the bushing slightly to align the hinge and locking plate screw holes. 8. Replace the door...

  • Page 19

    17 5. Using the two screws, attach the base grille assembly to the refrigerator as shown. Note: drive in the right side screw first. 4. Trim the skirt by scoring the proper “v” groove with a utility knife. Break the skirt at the score line. 3. Snap the skirt onto the base grille. Install side panel(...

  • Page 20

    18 complete installation 1. Turn the water supply line valve to the “open” position. 2. Turn the refrigerator switch to the on position. See power on/ off switch in the use and care manual for instructions. Wait a few minutes. Check the water line connections for leaks. 3. Remove all boxes, parts pa...

  • Page 22

    Dacor ● 14425 clark avenue, city of industry, ca 91745 ● phone: (800) 793-0093 ● fax: (626) 403-3130 ● www.Dacor.Com.