Dacor DYRP36DS Planning manual
All specifications subject to change without notice.
Phone: (800) 793-0093
www.dacor.com
PLANNING
GUIDE
DYRP36DS, DYRP48DS
Discovery
®
36” and 48” Wide
Dual Fuel Ranges
Document # PG05-010
Revised 09/03/14 Page 1/3
Width:
DYRP36D[-C-]S - 35 7/8” (91.1 cm)
DYRP48D[-C-]S - 47 7/8” (121.6 cm)
* The optional backguard is available in two heights;
3 and 9 inches high.
Product tolerances: +/- 1/16” (+/- 1.6 mm)
unless otherwise stated
WARNING
• Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
• This appliance must be installed in accordance with the
accompanying installation instructions.
48” (121.9 cm)
Front of open door
Front of handle
Front edge of bull nose
Front panel
Rear of front panel/oven door
28 1/2” (72.4 cm)
(91.9 cm)
36 3/16”
(95.3 cm)
37 1/2”
26 7/8” (68.3 cm)
26” (66.0 cm)
24” (61.0 cm)
1 1/4”
(3.2 cm)
to
1 1/16” (2.7 cm) to cooking
surface (top of grates) from
top of trim
Finished side
panel
X
*
24” (61.0 cm)
Cabinet face
Stiffener
Cabinet face**
Countertop*
*
IMPORTANT: See “CUTOUT WITH OPTIONAL ERV DOWNDRAFT VENT”
for countertop cutout dimensions.
*** Includes 3/16” (5 mm) space between downdraft vent top cap and range.
**
IMPORTANT: Cabinet face must not stick out further than
back of control panel.
Back of
control
panel
ERV36-ER or
ERV48-ER
downdraft vent
DYRP36DS or
DYRP48DS Range
3/8” min. (1.0 cm)
space behind
doendraft vent
chassis to clear
stiffener
3/8” min. (1.0 cm)
flat countertop
overhang required
behind cutout
29 7/8” (75.9 cm)***
Countertop height:
36 3/16" (91.9 cm) min.
37 1/2” (95.3 cm) max.
Product Dimensions