Dacor EPICURE EG366 Use And Care Manual - Etting
6
7
s
ettinG
U
p
y
oUr
C
ooktop
b
Urner
a
ssembly
Stack Burner Assembly
Put the burner rings on the burner bases as shown
below. Match the correct sizes. The bottom of the
correct size burner ring fits inside the top of the
matching burner base.
Turn the ring until it drops into place. Twist each ring
back and forth slightly to make sure it is properly seated.
Put the burner caps on top of the burner rings. The ridge
around the bottom edge of the cap goes around the top
of the burner ring.
1.
2.
3.
Crown Burner Assembly
Put the burner head(s) in place as shown below. The
locating tab on the burner head goes in the keyed hole
as shown.
Put the burner ring(s) on the burner head(s) as shown
below. Match the tabs on the bottom of the ring to the
slots on the burner head. Twist each ring back and forth
slightly to make sure it is properly seated.
Put the burner cap(s) on top of the burner ring(s). The
ridge around the bottom edge of the cap goes around
the top of the burner ring.
1.
2.
3.
Crown Burner Assembly
Ridge on bottom
of Burner Cap
Put locating tab
into keyed hole
Slots
Tabs
Step
Step
Step
Keyed Hole
Burner Head
Burner Ring
Burner Base
Stack Burner Assembly
Ridge on bottom of
Burner Cap
Step
Step
Step
Burner Base
Burner Ring
WARNING
To avoid the chance of fire, explosion or carbon monoxide
poisoning, do not attempt to use your cooktop without the
burners completely and properly assembled. The burner
rings spread the flame evenly around the burner cap. The
burner rings must be properly seated for proper burner
lighting and operation.
Burner Locations
Crown Burner
Stack Burners
Crown Burner